DG413DVZ
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Package / Case | TSSOP |
| Number of Pins | 16 |
| Published | 1999 |
| JESD-609 Code | e3 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 16 |
| Resistance | 80Ohm |
| Terminal Finish | Matte Tin (Sn) - annealed |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| HTS Code | 8542.39.00.01 |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 4 |
| Supply Voltage | 15V |
| Terminal Pitch | 0.65mm |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Output | SEPARATE OUTPUT |
| Operating Supply Voltage | 28V |
| Temperature Grade | INDUSTRIAL |
| Number of Channels | 1 |
| Max Supply Voltage | 40V |
| Min Supply Voltage | 5V |
| Operating Supply Current | 100pA |
| Nominal Supply Current | 100pA |
| Max Supply Current | 1μA |
| Throw Configuration | SPST |
| Turn On Delay Time | 250 ns |
| Supply Type | Dual, Single |
| Neg Supply Voltage-Nom (Vsup) | -15V |
| Turn-Off Delay Time | 145 ns |
| Max Dual Supply Voltage | 20V |
| Min Dual Supply Voltage | 5V |
| Dual Supply Voltage | 18V |
| Off-state Isolation-Nom | 68 dB |
| Switching | BREAK-BEFORE-MAKE |
| Switch-on Time-Max | 175ns |
| Height Seated (Max) | 1.2mm |
| Length | 5mm |
| Width | 4.4mm |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
DG413DVZ Overview
Shipping overseas is convenient with the electronic component packed in TSSOP. Total terminations are 16. Due to its 1 channels, the electrical component produces high-quality output. When a voltage supply of 15V is used, the electronic component should be turned on and run. The internal resistance of this digital multiplexer is 80Ohm. To find out what the 16 pins do, please refer to the datasheets. Multiplexer or Switches is a typical switch device. Users should never supply a voltage higher than 40V to a switch device. Dual, Single supply type digital switch with a low cost. There should be 5V voltage fed to the electrical part below 5V. This digital switch can be operated with a current of 100pA. It may damage the digital multiplexer if the voltage is higher than 1μA. There's no problem with dual supply voltage for this switch device. However, it shouldn't exceed 20V. The voltage should be at least 5V if you are using dual power supplies. The analog switch ic utilizes SEPARATE OUTPUT outputs in total. The electronic component can function from 28V. Temperatures above 85°C degrees Celsius should not be operated by the multiplexer.
DG413DVZ Features
1 Channels
100pA Supply Current
DG413DVZ Applications
There are a lot of Intersil (Renesas Electronics America) DG413DVZ Analog Switches & Multiplexers ICs applications.
- Central office
- SDH
- PBX interfaces
- Power routing
- DSLAMs
- Channelized and Unchannelized DS3 applications
- Relay replacements
- MP3 players
- Imaging
- 65 V DACs
