Parameters |
Max Dual Supply Voltage |
22V |
On-State Resistance (Max) |
35Ohm |
Min Dual Supply Voltage |
7V |
Dual Supply Voltage |
15V |
Multiplexer/Demultiplexer Circuit |
1:1 |
Off-state Isolation-Nom |
68 dB |
Current - Leakage (IS(off)) (Max) |
250pA |
Channel Capacitance (CS(off), CD(off)) |
9pF 9pF |
Switch Circuit |
SPST - NO/NC |
Switch Time (Ton, Toff) (Max) |
175ns, 145ns |
Charge Injection |
5pC |
Crosstalk |
-85dB @ 1MHz |
Switching |
BREAK-BEFORE-MAKE |
Switch-on Time-Max |
220ns |
Drain to Source Resistance |
45Ohm |
Height |
1.55mm |
Length |
10mm |
Width |
4mm |
Radiation Hardening |
No |
RoHS Status |
ROHS3 Compliant |
Lead Free |
Lead Free |
Factory Lead Time |
1 Week |
Mount |
Surface Mount |
Mounting Type |
Surface Mount |
Package / Case |
16-SOIC (0.154, 3.90mm Width) |
Number of Pins |
16 |
Weight |
665.986997mg |
Operating Temperature |
-40°C~85°C TA |
Packaging |
Tape & Reel (TR) |
Published |
2009 |
JESD-609 Code |
e3 |
Pbfree Code |
yes |
Part Status |
Active |
Moisture Sensitivity Level (MSL) |
1 (Unlimited) |
Number of Terminations |
16 |
Resistance |
80Ohm |
Terminal Finish |
Matte Tin (Sn) |
Subcategory |
Multiplexer or Switches |
Max Power Dissipation |
600mW |
Technology |
CMOS |
Terminal Form |
GULL WING |
Peak Reflow Temperature (Cel) |
260 |
Number of Functions |
4 |
Supply Voltage |
15V |
Terminal Pitch |
1.27mm |
Time@Peak Reflow Temperature-Max (s) |
40 |
Base Part Number |
DG413 |
Output |
SEPARATE OUTPUT |
Pin Count |
16 |
Operating Supply Voltage |
15V |
Number of Channels |
1 |
Max Supply Voltage |
36V |
Min Supply Voltage |
13V |
Operating Supply Current |
1μA |
Nominal Supply Current |
100pA |
Power Dissipation |
600mW |
Max Supply Current |
1μA |
Throw Configuration |
SPST |
Turn On Delay Time |
175 ns |
Number of Inputs |
4 |
Voltage - Supply, Single/Dual (±) |
5V~44V ±5V~20V |
Supply Type |
Dual, Single |
Neg Supply Voltage-Nom (Vsup) |
-15V |
Turn-Off Delay Time |
145 ns |
DG413DY-T1-E3 Overview
Shipping overseas is convenient with the electronic component packed in 16-SOIC (0.154, 3.90mm Width). High reliability is achieved by using advanced packaging method Tape & Reel (TR). It is mounted in the position Surface Mount. 1:1 is the ratio of multiplexer to demultiplexer circuits. Operating temperature around -40°C~85°C TA extended. In total, there have been 16 terminations. Due to its 1 channels, the electrical component produces high-quality output. If the voltage supply is 15V volts, the electrical component should be turned on and run. It is part of the design of the 16 series that this electronic component is included. On the other hand, analog switches can be constructed using SPST - NO/NC switching circuits. Try searching with DG413 to find analog multiplexer variants. Internally, this switch multiplexer has a resistance of 80Ohm. Datasheets for 16 pin functions are available upon request. Theswitch device is a typical Multiplexer or Switches. Multiplexers should not be powered above 36V in normal situations. The digital multiplexer has a low cost Dual, Single supply. It is recommended to use 13V as the lowest voltage for the electrical part. 1μA current would be enough for this multiplexer to operate. Put voltage above 1μA on the multiplexer to cause damage. If put voltage greater than 22V on the multiplexer, damage may be caused to the device. It is recommended that you attach at least 7V to your dual power supply. The analog switch ic utilizes SEPARATE OUTPUT outputs in total. 15V operating voltages can be used with this electrical part. A 4 input needs to be operated. Resistivity from Drain to Source is 45Ohm for this electronic part.
DG413DY-T1-E3 Features
1 Channels
Switch Circuit: SPST - NO/NC
1μA Supply Current
Drain-to-Source resistance: 45Ohm
DG413DY-T1-E3 Applications
There are a lot of Vishay Siliconix DG413DY-T1-E3 Analog Switches & Multiplexers ICs applications.
- Switching Systems
- Microprocessor Controlled Analog Systems
- Digital access cross connects
- Optical Applications
- Digital Cross-Connects
- Cable Telephony – NIU, Set-Top Box, Home Side Box
- Remote wireless modules
- E1 Multiplexer
- Cable Modem
- Audio and video signal routing