DG4157DN-T1-E4
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 6-UFDFN |
| Number of Pins | 6 |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tape & Reel (TR) |
| Published | 2016 |
| Pbfree Code | yes |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Resistance | 1.2Ohm |
| Max Power Dissipation | 160mW |
| Base Part Number | DG4157 |
| Pin Count | 6 |
| Number of Circuits | 1 |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 1.65V |
| Operating Supply Current | 50nA |
| Max Supply Current | 500nA |
| Turn On Delay Time | 55 ns |
| Supply Type | Single |
| Turn-Off Delay Time | 27 ns |
| -3db Bandwidth | 117MHz |
| On-State Resistance (Max) | 1.2Ohm |
| Multiplexer/Demultiplexer Circuit | 2:1 |
| Current - Leakage (IS(off)) (Max) | 2nA |
| Channel Capacitance (CS(off), CD(off)) | 20pF |
| Switch Circuit | SPDT |
| Switch Time (Ton, Toff) (Max) | 37ns, 23ns |
| Charge Injection | 50pC |
| Channel-to-Channel Matching (ΔRon) | 120m Ω (Max) |
| Crosstalk | -63dB @ 1MHz |
| Voltage - Supply, Single (V+) | 1.65V~5.5V |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
DG4157DN-T1-E4 Overview
The electronic part can be shipped overseas conveniently because it is packaged in 6-UFDFN. This packaging method provides high reliability because it uses advanced packaging techniques. Mounted in Surface Mount is this multiplexer. Multiplexers and demultiplexers have a number of circuits 2:1. The operating temperature is extended to around -40°C~85°C TA. Electronic part bodies are injected with 6 pins. The analog switch ics are built using SPDT switching circuits. There are 1 circuits in this multiplexer. Search with DG4157 if you are looking for analog multiplexer variants. It has an internal resistance of 1.2Ohm. The functions of 6 pins can be found in the datasheets. Users should never supply a voltage higher than 5.5V to a switch device. A cost-effective Single supply type analogue multiplexer. It is recommended to use 1.65V as the lowest voltage for the electrical part. An operating current of 50nA would be sufficient for this switch device. Using only a single voltage supply, this analog switch requires 1.65V~5.5V voltage. Putting voltage greater than 500nA on the multiplexer may cause damage.
DG4157DN-T1-E4 Features
Switch Circuit: SPDT
50nA Supply Current
-3db Bandwidth: 117MHz
DG4157DN-T1-E4 Applications
There are a lot of Vishay Siliconix DG4157DN-T1-E4 Analog Switches & Multiplexers ICs applications.
- RGB switches
- Cable Modem
- Fiber In The Loop (FITL)
- Isolation
- Precision test equipment
- Intelligent PBX
- USB 1.1 signal switching circuits
- Central office
- Remote Powered Equipment
- Avionics test equipment
