DG417DY
| Parameters | |
|---|---|
| On-State Resistance (Max) | 35Ohm |
| Min Dual Supply Voltage | 7V |
| Dual Supply Voltage | 15V |
| Multiplexer/Demultiplexer Circuit | 1:1 |
| Current - Leakage (IS(off)) (Max) | 250pA |
| Channel Capacitance (CS(off), CD(off)) | 8pF 8pF |
| Switch Circuit | SPST - NC |
| Switch Time (Ton, Toff) (Max) | 175ns, 145ns |
| Charge Injection | 60pC |
| Switching | BREAK-BEFORE-MAKE |
| Drain to Source Resistance | 20mOhm |
| Normal Position | NC |
| Height | 1.55mm |
| Length | 5mm |
| Width | 4mm |
| Radiation Hardening | No |
| RoHS Status | Non-RoHS Compliant |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 8-SOIC (0.154, 3.90mm Width) |
| Number of Pins | 8 |
| Weight | 540.001716mg |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tube |
| Published | 2015 |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 8 |
| Resistance | 35Ohm |
| Terminal Finish | Tin/Lead (Sn/Pb) |
| Subcategory | Multiplexer or Switches |
| Max Power Dissipation | 400mW |
| Technology | CMOS |
| Terminal Form | GULL WING |
| Number of Functions | 1 |
| Pin Count | 8 |
| Max Supply Voltage | 36V |
| Min Supply Voltage | 13V |
| Power Dissipation | 400mW |
| Max Supply Current | 1μA |
| Turn On Delay Time | 175 ns |
| Number of Inputs | 1 |
| Voltage - Supply, Single/Dual (±) | 12V ±15V |
| Supply Type | Dual, Single |
| Turn-Off Delay Time | 145 ns |
| Max Dual Supply Voltage | 22V |
DG417DY Overview
As the electronic part is packed in 8-SOIC (0.154, 3.90mm Width), international shipping is convenient. High reliability is achieved by using advanced packaging method Tube. The multiplexer is located in Surface Mount. Multiplexer and demultiplexer circuits have a number 1:1. Extended operating temperature around -40°C~85°C TA. Total terminations are 8. This electronic part can be found in the 8 series. Based on SPST - NC switching circuits, these analog multiplexers work. As far as internal resistance is concerned, it has 35Ohm. For details about the functions of 8 pins, please refer to the datasheets. This switch device is a typical Multiplexer or Switches. It is normally recommended that users do not supply the multiplexer with voltages higher than 36V. Dual, Single supply type digital switch with a low cost. 13V should be the lowest voltage fed to the electronic component. The switch multiplexer may be damaged if it is exposed to voltage greater than 1μA. Despite this switch's dual supply capability, its voltage should not exceed 22V. With dual power supplies, you should attach at least 7V. A 1 input needs to be operated. There is 20mOhm Drain to Source resistance on this electronic part.
DG417DY Features
Switch Circuit: SPST - NC
Drain-to-Source resistance: 20mOhm
DG417DY Applications
There are a lot of Vishay Siliconix DG417DY Analog Switches & Multiplexers ICs applications.
- Channel Banks
- Data switching
- Digital Cross-Connects
- Voice over IP/DSL – Integrated Access Devices, Smart
- Communications systems
- Power routing
- Access Concentrators
- Relay replacements
- Fault Tolerant Systems
- Cable Modem
