DG429DW
| Parameters | |
|---|---|
| Mounting Type | Surface Mount |
| Package / Case | 18-SOIC (0.295, 7.50mm Width) |
| Supplier Device Package | 18-SOIC W |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tube |
| Published | 2016 |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Resistance | 100Ohm |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Max Power Dissipation | 470mW |
| Number of Channels | 2 |
| Number of Circuits | 2 |
| Max Supply Voltage | 36V |
| Min Supply Voltage | 13V |
| Max Supply Current | 100μA |
| Propagation Delay | 250 ns |
| Turn On Delay Time | 300 ns |
| Voltage - Supply, Single/Dual (±) | 12V ±15V |
| Supply Type | Dual, Single |
| Turn-Off Delay Time | 300 ns |
| Max Dual Supply Voltage | 22V |
| On-State Resistance (Max) | 100Ohm |
| Min Dual Supply Voltage | 7V |
| Multiplexer/Demultiplexer Circuit | 4:1 |
| Current - Leakage (IS(off)) (Max) | 500pA |
| Channel Capacitance (CS(off), CD(off)) | 11pF 20pF |
| Switch Circuit | SP4T |
| Switch Time (Ton, Toff) (Max) | 150ns, 150ns |
| Charge Injection | 1pC |
| Channel-to-Channel Matching (ΔRon) | 5Ohm |
| Drain to Source Resistance | 100Ohm |
| Height | 2.6mm |
| Length | 12.45mm |
| Width | 8mm |
| Radiation Hardening | No |
| RoHS Status | Non-RoHS Compliant |
DG429DW Overview
Due to its 18-SOIC (0.295, 7.50mm Width) packaging, the electronic part is convenient for international shipping. Advanced packaging method Tube is used to provide high reliability. In Surface Mount, this analog switch is mounted. Multiplexers and demultiplexers have a number of circuits 4:1. Operational temperature extended around -40°C~85°C TA. By its 2 channels, the electronic component provides high-quality output. Multiplexers built on a SP4T switching circuit are built. There are 2 circuits in this switch device. It has an internal resistance of 100Ohm. normally, users should not supply switches with voltages higher than 36V. Analog switch ics with Dual, Single supply type are cost-effective. It is recommended to use 13V as the lowest voltage for the electrical part. Putting voltage greater than 100μA on the multiplexer may cause damage. There is no problem with using dual supply voltage, but it should not exceed 22V. With dual power supplies, you should attach at least 7V. An environment with a temperature greater than 85°C should not be used to operate the digital switches. There is 100Ohm resistance between Drain and Source for this electronic part. Suppliers offer the 18-SOIC W package.
DG429DW Features
2 Channels
Switch Circuit: SP4T
Drain-to-Source resistance: 100Ohm
DG429DW Applications
There are a lot of Vishay Siliconix DG429DW Analog Switches & Multiplexers ICs applications.
- RGB switches
- Imaging
- Fiber In The Loop (FITL)
- Precision test equipment
- Data Acquisition Systems
- Automatic test equipment
- Communication systems
- Sample-and-hold systems
- Channel Banks
- Industrial control systems
