DG441DJ

250ns, 120ns SPST - NC 85Ohm Analog Switches BREAK-BEFORE-MAKE DG441 16 Pins 500pA 15V 16-DIP (0.300, 7.62mm)

Manufacturer: Maxim Integrated
Nocochips NO: 503-DG441DJ
Package: 16-DIP (0.300, 7.62mm)
Datasheet: PDF
Stock: 191
Description: 250ns, 120ns SPST - NC 85Ohm Analog Switches BREAK-BEFORE-MAKE DG441 16 Pins 500pA 15V 16-DIP (0.300, 7.62mm)(Kg)

Details

Tags

Parameters
Nominal Supply Current	15μA
Max Supply Current	100μA
Throw Configuration	SPST
Turn On Delay Time	250 ns
Voltage - Supply, Single/Dual (±)	10V~30V ±4.5V~20V
Supply Type	Dual, Single
Neg Supply Voltage-Nom (Vsup)	-15V
Turn-Off Delay Time	170 ns
Max Dual Supply Voltage	20V
On-State Resistance (Max)	85Ohm
Min Dual Supply Voltage	4.5V
Multiplexer/Demultiplexer Circuit	1:1
Off-state Isolation-Nom	60 dB
Current - Leakage (IS(off)) (Max)	500pA
Channel Capacitance (CS(off), CD(off))	4pF 4pF
On-state Resistance Match-Nom	4Ohm
Switch Circuit	SPST - NC
Switch Time (Ton, Toff) (Max)	250ns, 120ns
Charge Injection	5pC
Channel-to-Channel Matching (ΔRon)	4 Ω (Max)
Crosstalk	-100dB @ 1MHz
Switching	BREAK-BEFORE-MAKE
Switch-off Time-Max	120ns
Drain to Source Resistance	50Ohm
Normal Position	NC
Height	4.45mm
Length	19.43mm
Width	7.87mm
Radiation Hardening	No
REACH SVHC	Unknown
RoHS Status	Non-RoHS Compliant
Lead Free	Contains Lead
Mount	Through Hole
Mounting Type	Through Hole
Package / Case	16-DIP (0.300, 7.62mm)
Number of Pins	16
Operating Temperature	-40°C~85°C TA
Packaging	Tube
Published	2009
JESD-609 Code	e0
Pbfree Code	no
Part Status	Obsolete
Moisture Sensitivity Level (MSL)	1 (Unlimited)
Number of Terminations	16
ECCN Code	EAR99
Resistance	160Ohm
Terminal Finish	Tin/Lead (Sn85Pb15)
Subcategory	Multiplexer or Switches
Max Power Dissipation	842mW
Technology	CMOS
Peak Reflow Temperature (Cel)	240
Number of Functions	4
Supply Voltage	15V
Time@Peak Reflow Temperature-Max (s)	20
Base Part Number	DG441
Output	SEPARATE OUTPUT
Pin Count	16
Operating Supply Voltage	18V
Power Supplies	+-15V
Number of Channels	4
Max Supply Voltage	30V
Min Supply Voltage	10V

DG441DJ Overview

The electronic component is convenient to ship overseas because it is packed in a 16-DIP (0.300, 7.62mm). To ensure high reliability, a new packaging method Tube is used. This analog switch is mounted in Through Hole. Multiplexers and demultiplexers have a number of circuits 1:1. An extended operating temperature of -40°C~85°C TA degrees Celsius. 16 terminations have been made so far. A high-quality output is provided by the electrical component's 4 channels. With a 15V voltage supply, the electrical component should be turned on and run. The electrical component body receives 16 pins. Unlike digital switches, these are based on SPST - NC switching circuits. Look for analog switch ic variants by searching with DG441. There is 160Ohm internal resistance in this digital multiplexer. Datasheets for functions of 16 pins are available. The analog multiplexer shown here is a typical Multiplexer or Switches. normally, users should not supply switches with voltages higher than 30V. A analog switch ic that has a cost-effective Dual, Single supply type. The lowest voltage fed to the electronic component should be 10V. When the digital multiplexer is charged above 100μA, damage can occur. It is possible to supply this switch device with dual voltages. However, it is not advisable to exceed 20V. If you are using a dual power supply, you should attach at least 4.5V. The digital multiplexer has SEPARATE OUTPUT outputs that can be used. There is a voltage range of 18V operating voltages for the electrical part. This electronic component presents a Drain to Source resistance of 50Ohm.