DG441DVZ
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Package / Case | TSSOP |
| Number of Pins | 16 |
| Published | 1999 |
| JESD-609 Code | e3 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 16 |
| Resistance | 160Ohm |
| Terminal Finish | Matte Tin (Sn) - annealed |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Additional Feature | IT CAN ALSO OPERATE WITH 5V TO 34V SINGLE SUPPLY |
| HTS Code | 8542.39.00.01 |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 4 |
| Supply Voltage | 15V |
| Terminal Pitch | 0.65mm |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Output | SEPARATE OUTPUT |
| Operating Supply Voltage | 18V |
| Temperature Grade | INDUSTRIAL |
| Number of Channels | 1 |
| Max Supply Voltage | 40V |
| Min Supply Voltage | 5V |
| Operating Supply Current | 15μA |
| Nominal Supply Current | 15μA |
| Max Supply Current | 100μA |
| Throw Configuration | SPST |
| Turn On Delay Time | 450 ns |
| Supply Type | Dual, Single |
| Neg Supply Voltage-Nom (Vsup) | -15V |
| Turn-Off Delay Time | 200 ns |
| Max Dual Supply Voltage | 20V |
| Min Dual Supply Voltage | 5V |
| Dual Supply Voltage | 18V |
| Off-state Isolation-Nom | 60 dB |
| Switching | BREAK-BEFORE-MAKE |
| Switch-on Time-Max | 250ns |
| Switch-off Time-Max | 120ns |
| Normal Position | NC |
| Height Seated (Max) | 1.2mm |
| Length | 5mm |
| Width | 4.4mm |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
DG441DVZ Overview
Packed in TSSOP, the electronic component is convenient for shipping overseas. A total of 16 terminations have been recorded. A high-quality output is provided by the electrical component's 1 channels. When a voltage supply of 15V is used, the electronic component should be turned on and run. Analog switches have 160Ohm internal resistance. Datasheets for functions of 16 pins are available. There is Multiplexer or Switches analog multiplexer like this in the world. Users shouldn't supply more than 40V voltage to the switch device. An effective Dual, Single supply digital multiplexer. It is recommended to use 5V as the lowest voltage for the electrical part. The analogue multiplexer could operate on 15μA current. It may damage the digital multiplexer if the voltage is higher than 100μA. If put voltage greater than 20V on the multiplexer, damage may be caused to the device. A dual power supply should have at least 5V voltage attached. As far as the outputs go, this switch multiplexer utilizes SEPARATE OUTPUT of them. A voltage of 18V can be used to operate the electronic component. Don't miss this electronic component's additional features, such as: IT CAN ALSO OPERATE WITH 5V TO 34V SINGLE SUPPLY. A temperature above 85°C is not suitable for operation of the analogue multiplexer.
DG441DVZ Features
1 Channels
15μA Supply Current
Additional Features: IT CAN ALSO OPERATE WITH 5V TO 34V SINGLE SUPPLY
DG441DVZ Applications
There are a lot of Intersil (Renesas Electronics America) DG441DVZ Analog Switches & Multiplexers ICs applications.
- Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
- Transmit
- PCMCIA cards
- Communication systems
- Audio signal routing
- Sample hold systems
- ADCs such as AD7840/8, AD7870/1/2/4/5/6/8
- Power routing
- RGB switches
- Mechanical reed relay replacement
