DG442DJZ
| Parameters | |
|---|---|
| Mounting Type | Through Hole |
| Package / Case | 16-DIP (0.300, 7.62mm) |
| Surface Mount | NO |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tube |
| JESD-609 Code | e3 |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 16 |
| Terminal Finish | Matte Tin (Sn) - annealed |
| Technology | CMOS |
| Terminal Position | DUAL |
| Peak Reflow Temperature (Cel) | NOT APPLICABLE |
| Number of Functions | 4 |
| Supply Voltage | 15V |
| Time@Peak Reflow Temperature-Max (s) | NOT APPLICABLE |
| Base Part Number | DG442 |
| Pin Count | 16 |
| JESD-30 Code | R-PDIP-T16 |
| Qualification Status | Not Qualified |
| Number of Channels | 1 |
| Number of Circuits | 4 |
| Voltage - Supply, Single/Dual (±) | 5V~34V ±5V~22V |
| Neg Supply Voltage-Nom (Vsup) | -15V |
| On-State Resistance (Max) | 85Ohm |
| Multiplexer/Demultiplexer Circuit | 1:1 |
| Off-state Isolation-Nom | 60 dB |
| Current - Leakage (IS(off)) (Max) | 500pA |
| Channel Capacitance (CS(off), CD(off)) | 4pF 4pF |
| Switch Circuit | SPST - NO |
| Switch Time (Ton, Toff) (Max) | 250ns, 210ns |
| Charge Injection | -1pC |
| Crosstalk | -100dB @ 1MHz |
| Switch-on Time-Max | 250ns |
| Switch-off Time-Max | 210ns |
| Drain to Source Resistance | 85Ohm |
| Height Seated (Max) | 5.33mm |
| Length | 19.17mm |
| Width | 7.62mm |
| RoHS Status | ROHS3 Compliant |
DG442DJZ Overview
This electronic part is conveniently packaged in 16-DIP (0.300, 7.62mm), making it easy to ship abroad. A high level of reliability can be achieved through the use of an advanced packaging method Tube. In Through Hole, this analog switch is mounted. Multiplexers and demultiplexers have a ratio of 1:1. Temperatures around -40°C~85°C TA are extended for operation. A total of 16 terminations have been recorded. The electronic part provides high-quality output because it has 1 channels. If the voltage supply is 15V volts, the electrical component should be turned on and run. As part of the design of the 16 series, this electronic part has been incorporated into the system. These analog multiplexers are built based on SPST - NO switching circuits. This multiplexer is composed of 4 circuits. Try searching for DG442 variants of the analog switch ic. This electronic component presents a Drain to Source resistance of 85Ohm.
DG442DJZ Features
1 Channels
Switch Circuit: SPST - NO
Drain-to-Source resistance: 85Ohm
DG442DJZ Applications
There are a lot of Renesas Electronics America Inc. DG442DJZ Analog Switches & Multiplexers ICs applications.
- USB 1.1 signal switching circuits
- ATM
- Sample hold systems
- PDAs
- Wireless Local Loop
- SONET/SDH ADM
- Optical Applications
- Signal routing between systems
- Fault Tolerant Systems
- T1/E1 Terminals
