DG444DJ

250ns, 140ns SPST - NC 85Ohm Analog Switches BREAK-BEFORE-MAKE DG444 16 Pins 500pA 10V 16-DIP (0.300, 7.62mm)

Manufacturer: Maxim Integrated
Nocochips NO: 503-DG444DJ
Package: 16-DIP (0.300, 7.62mm)
Datasheet: PDF
Stock: 188
Description: 250ns, 140ns SPST - NC 85Ohm Analog Switches BREAK-BEFORE-MAKE DG444 16 Pins 500pA 10V 16-DIP (0.300, 7.62mm)(Kg)

Details

Tags

Parameters
Number of Terminations	16
ECCN Code	EAR99
Resistance	85Ohm
Terminal Finish	Tin/Lead (Sn85Pb15)
Subcategory	Multiplexer or Switches
Max Power Dissipation	842mW
Technology	CMOS
Peak Reflow Temperature (Cel)	240
Number of Functions	4
Supply Voltage	10V
Time@Peak Reflow Temperature-Max (s)	20
Base Part Number	DG444
Output	SEPARATE OUTPUT
Pin Count	16
Operating Supply Voltage	18V
Power Supplies	512/+-15V
Number of Channels	4
Max Supply Voltage	24V
Min Supply Voltage	10V
Nominal Supply Current	30mA
Max Supply Current	1μA
Throw Configuration	SPST
Turn On Delay Time	150 ns
Voltage - Supply, Single/Dual (±)	10V~30V ±4.5V~20V
Supply Type	Dual, Single
Neg Supply Voltage-Nom (Vsup)	-10V
Turn-Off Delay Time	90 ns
Max Dual Supply Voltage	20V
On-State Resistance (Max)	85Ohm
Min Dual Supply Voltage	4.5V
Multiplexer/Demultiplexer Circuit	1:1
Off-state Isolation-Nom	60 dB
Current - Leakage (IS(off)) (Max)	500pA
Channel Capacitance (CS(off), CD(off))	4pF 4pF
On-state Resistance Match-Nom	4Ohm
Switch Circuit	SPST - NC
Switch Time (Ton, Toff) (Max)	250ns, 140ns
Charge Injection	5pC
Channel-to-Channel Matching (ΔRon)	4 Ω (Max)
Crosstalk	-100dB @ 1MHz
Switching	BREAK-BEFORE-MAKE
Switch-on Time-Max	250ns
Switch-off Time-Max	120ns
Drain to Source Resistance	50Ohm
Normal Position	NC
Height	4.45mm
Length	19.43mm
Width	7.87mm
Radiation Hardening	No
REACH SVHC	No SVHC
RoHS Status	Non-RoHS Compliant
Lead Free	Contains Lead
Mount	Through Hole
Mounting Type	Through Hole
Package / Case	16-DIP (0.300, 7.62mm)
Number of Pins	16
Operating Temperature	-40°C~85°C TA
Packaging	Tube
Published	2005
JESD-609 Code	e0
Pbfree Code	no
Part Status	Obsolete
Moisture Sensitivity Level (MSL)	1 (Unlimited)

DG444DJ Overview

The electronic part can be shipped overseas conveniently because it is packaged in 16-DIP (0.300, 7.62mm). High reliability is provided by advanced packaging method Tube. Mounted in Through Hole is this multiplexer. Multiplexers and demultiplexers have the same number of circuits 1:1. Operational temperature extended around -40°C~85°C TA. In total, 16 terminations have occurred. The electronic part delivers high-quality output through its 4 channels. It is safe to turn on and run the electronic component with a 10V voltage supply. An electrical component like this is included in the 16 series. A SPST - NC switching circuit is used to build these analog multiplexers. Search with DG444 if you are looking for analog multiplexer variants. It has an internal resistance of 85Ohm. The functions of 16 pins can be found in the datasheets. Multiplexer or Switches is a typical switch device. A voltage higher than 24V should not normally be supplied to the switches. Analogue multiplexers of the Dual, Single supply type that are cost-effective. A low voltage of 10V should be applied to the electronic component. The switch multiplexer may be damaged if it is exposed to voltage greater than 1μA. There's no problem with dual supply voltage for this switch device. However, it shouldn't exceed 20V. If you are using dual power supplies, you should attach at least 4.5V. The outputs of this digital multiplexer are SEPARATE OUTPUT in number. This electrical part is compatible with 18V operating voltages. It has a Drain to Source resistance of 50Ohm ohms.