DG445BDN-T1-E4

300ns, 200ns SPST - NO 80Ohm QUAD Analog Switches BREAK-BEFORE-MAKE DG445 16 Pins 500pA 15V 16-VQFN Exposed Pad

Manufacturer: Vishay Siliconix
Nocochips NO: 880-DG445BDN-T1-E4
Package: 16-VQFN Exposed Pad
Datasheet: PDF
Stock: 120
Description: 300ns, 200ns SPST - NO 80Ohm QUAD Analog Switches BREAK-BEFORE-MAKE DG445 16 Pins 500pA 15V 16-VQFN Exposed Pad(Kg)

Details

Tags

Parameters
Factory Lead Time	1 Week
Mount	Surface Mount
Mounting Type	Surface Mount
Package / Case	16-VQFN Exposed Pad
Number of Pins	16
Weight	57.09594mg
Operating Temperature	-40°C~85°C TA
Packaging	Tape & Reel (TR)
Published	2016
JESD-609 Code	e4
Pbfree Code	yes
Part Status	Active
Moisture Sensitivity Level (MSL)	1 (Unlimited)
Number of Terminations	16
Resistance	160Ohm
Terminal Finish	PALLADIUM GOLD OVER NICKEL
Subcategory	Multiplexer or Switches
Max Power Dissipation	850mW
Technology	CMOS
Terminal Position	QUAD
Terminal Form	NO LEAD
Peak Reflow Temperature (Cel)	260
Number of Functions	4
Supply Voltage	15V
Terminal Pitch	0.65mm
Reach Compliance Code	unknown
Time@Peak Reflow Temperature-Max (s)	30
Base Part Number	DG445
Output	SEPARATE OUTPUT
Pin Count	16
Qualification Status	Not Qualified
Number of Channels	1
Number of Circuits	4
Max Supply Voltage	36V
Min Supply Voltage	13V
Operating Supply Current	5μA
Max Supply Current	1μA
Throw Configuration	SPST
Turn On Delay Time	300 ns
Voltage - Supply, Single/Dual (±)	12V ±15V
Supply Type	Dual, Single
Neg Supply Voltage-Nom (Vsup)	-15V
Turn-Off Delay Time	200 ns
Max Dual Supply Voltage	22V
On-State Resistance (Max)	80Ohm
Min Dual Supply Voltage	7V
Dual Supply Voltage	15V
Multiplexer/Demultiplexer Circuit	1:1
Off-state Isolation-Nom	90 dB
Current - Leakage (IS(off)) (Max)	500pA
Channel Capacitance (CS(off), CD(off))	5pF 5pF
Switch Circuit	SPST - NO
Switch Time (Ton, Toff) (Max)	300ns, 200ns
Charge Injection	1pC
Crosstalk	-95dB @ 100kHz
Switching	BREAK-BEFORE-MAKE
Normal Position	NO
Height	950μm
Length	4mm
Width	4mm
RoHS Status	ROHS3 Compliant

DG445BDN-T1-E4 Overview

Presented in 16-VQFN Exposed Pad, this electrical component is convenient for overseas shipping. A high level of reliability can be achieved through the use of an advanced packaging method Tape & Reel (TR). In Surface Mount, this analog switch is mounted. Multiplexers and demultiplexers have the same number of circuits 1:1. An extended operating temperature of -40°C~85°C TA degrees Celsius. Total terminations are 16. The electronic part delivers high-quality output through its 1 channels. An 15V voltage supply should allow the electrical part to be turned on and run. There is an electrical component included in the 16 series. On the other hand, analog switches can be constructed using SPST - NO switching circuits. Circuits number 4 make up this analogue multiplexer. Try searching with DG445 to find analog multiplexer variants. An switch multiplexer with 160Ohm internal resistance has a value of 160Ohm. Datasheets for functions of 16 pins are available. This switch device is a typical Multiplexer or Switches. A voltage higher than 36V should not normally be supplied to the switches. A analog switch ic that has a cost-effective Dual, Single supply type. 13V should be the lowest voltage fed to the electronic component. This multiplexer would work with 5μA current. If put voltage greater than 1μA on the device, damage may be caused to the analogue multiplexer. Despite this switch's dual supply capability, its voltage should not exceed 22V. When using dual power supplies, you should attach at least 7V. SEPARATE OUTPUT outputs are utilized by this digital multiplexer.