DG641DY
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 16-SOIC (0.154, 3.90mm Width) |
| Number of Pins | 16 |
| Weight | 547.485991mg |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tube |
| Published | 2005 |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 16 |
| Resistance | 15Ohm |
| Terminal Finish | Tin/Lead (Sn/Pb) |
| Subcategory | Multiplexer or Switches |
| Max Power Dissipation | 600mW |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Number of Functions | 4 |
| Terminal Pitch | 1.27mm |
| Output | SEPARATE OUTPUT |
| Pin Count | 16 |
| Operating Supply Voltage | 15V |
| Power Supplies | 15-3V |
| Max Supply Voltage | 18V |
| Min Supply Voltage | 10V |
| Power Dissipation | 600mW |
| Max Supply Current | 6mA |
| Turn On Delay Time | 70 ns |
| Number of Inputs | 4 |
| Voltage - Supply, Single/Dual (±) | 3V~15V ±3V~15V |
| Supply Type | Single |
| Bandwidth | 500MHz |
| Turn-Off Delay Time | 50 ns |
| Max Dual Supply Voltage | 15V |
| On-State Resistance (Max) | 15Ohm |
| Min Dual Supply Voltage | 10V |
| Dual Supply Voltage | 12V |
| Multiplexer/Demultiplexer Circuit | 1:1 |
| Current - Leakage (IS(off)) (Max) | 10nA |
| Channel Capacitance (CS(off), CD(off)) | 12pF 12pF |
| Switch Circuit | SPST - NO |
| Switch Time (Ton, Toff) (Max) | 70ns, 50ns |
| Charge Injection | 19pC |
| Channel-to-Channel Matching (ΔRon) | 1 Ω |
| Crosstalk | -87dB @ 5MHz |
| Switching | BREAK-BEFORE-MAKE |
| Drain to Source Resistance | 15Ohm |
| Normal Position | NC |
| Height | 1.55mm |
| Length | 10mm |
| Width | 4mm |
| Radiation Hardening | No |
| RoHS Status | Non-RoHS Compliant |
DG641DY Overview
Shipping overseas is convenient due to the electrical component's packing in 16-SOIC (0.154, 3.90mm Width). High reliability is achieved by using advanced packaging method Tube. Mounted in Surface Mount is this multiplexer. Multiplexers and demultiplexers have a ratio of 1:1. Operating temperature extended to -40°C~85°C TA. The total number of terminations is 16. The electrical component body receives 16 pins. The analog switch ics are built using SPST - NO switching circuits. There is 15Ohm internal resistance in this digital multiplexer. The functions of 16 pins can be found in the datasheets. In this analog multiplexer, the value is Multiplexer or Switches. normally, users should not supply switches with voltages higher than 18V. The digital multiplexer has a low cost Single supply. The lowest voltage the electronic part should receive is 10V. If put voltage greater than 6mA on the device, damage may be caused to the analogue multiplexer. There's no problem with dual supply voltage for this switch device. However, it shouldn't exceed 15V. If you are using dual power supplies, you should attach at least 10V. The outputs of this digital multiplexer are SEPARATE OUTPUT in number. 15V operating voltages are supported by the electronic component. There are 4 inputs to be operated. In 500MHz-bandwidths, data can be transferred. It has a Drain to Source resistance of 15Ohm ohms.
DG641DY Features
Switch Circuit: SPST - NO
Bandwidth: 500MHz
Drain-to-Source resistance: 15Ohm
DG641DY Applications
There are a lot of Vishay Siliconix DG641DY Analog Switches & Multiplexers ICs applications.
- Remote wireless modules
- PCMCIA cards
- Wireless Local Loop
- Fault Tolerant Systems
- PDH Multiplexers
- Microprocessor Controlled Analog Systems
- Audio/video switches
- Remote Powered Equipment
- New designs requiring multiplexer functions
- Cell phones
