DG9262DY
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 8-SOIC (0.154, 3.90mm Width) |
| Number of Pins | 8 |
| Weight | 540.001716mg |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tube |
| Published | 2009 |
| Pbfree Code | no |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Resistance | 60Ohm |
| Max Power Dissipation | 400mW |
| Reach Compliance Code | unknown |
| Pin Count | 8 |
| Max Supply Voltage | 12V |
| Min Supply Voltage | 2.7V |
| Power Dissipation | 400mW |
| Max Supply Current | 1μA |
| Turn On Delay Time | 75 ns |
| Number of Inputs | 2 |
| Supply Type | Single |
| Turn-Off Delay Time | 50 ns |
| On-State Resistance (Max) | 60Ohm |
| Multiplexer/Demultiplexer Circuit | 1:1 |
| Current - Leakage (IS(off)) (Max) | 100pA |
| Channel Capacitance (CS(off), CD(off)) | 7pF |
| Switch Circuit | SPST - NC |
| Switch Time (Ton, Toff) (Max) | 75ns, 50ns |
| Charge Injection | 2pC |
| Channel-to-Channel Matching (ΔRon) | 400m Ω |
| Crosstalk | -90dB @ 1MHz |
| Voltage - Supply, Single (V+) | 2.7V~12V |
| Drain to Source Resistance | 40Ohm |
| Height | 1.55mm |
| Length | 5mm |
| Width | 4mm |
| RoHS Status | Non-RoHS Compliant |
DG9262DY Overview
Presented in 8-SOIC (0.154, 3.90mm Width), this electrical component is convenient for overseas shipping. Advanced packaging method Tube is used to provide high reliability. This analog switch is mounted in Surface Mount. The ratio between the number of multiplexer and demultiplexer circuits is 1:1. An extended operating temperature of -40°C~85°C TA degrees Celsius. This electronic part can be found in the 8 series. The analog switch ics are built using SPST - NC switching circuits. It has an internal resistance of 60Ohm. Datasheets for functions of 8 pins are available. It is generally not recommended to supply a voltage higher than 12V to the switch device in normal circumstances. Analogue multiplexer with a Single supply type that is cost-effective. 2.7V is the lowest voltage that should be fed to the electronic electronic part. A voltage of 2.7V~12V is required for this switch device, which drains from a single voltage source. When the digital multiplexer is charged above 1μA, damage can occur. A 2 input needs to be operated. It has a Drain to Source resistance of 40Ohm ohms.
DG9262DY Features
Switch Circuit: SPST - NC
Drain-to-Source resistance: 40Ohm
DG9262DY Applications
There are a lot of Vishay Siliconix DG9262DY Analog Switches & Multiplexers ICs applications.
- Routers
- PDAs
- Sample hold systems
- Digital cross connects (DSX-1)
- Digital Cross-Connects
- Switching Systems
- Cable Modem
- DVD-R
- Imaging
- Multiplexers
