DG9424DQ-T1
| Parameters | |
|---|---|
| Mounting Type | Surface Mount |
| Package / Case | 16-TSSOP (0.173, 4.40mm Width) |
| Number of Pins | 16 |
| Supplier Device Package | 16-TSSOP |
| Weight | 172.98879mg |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tape & Reel (TR) |
| Published | 2005 |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Resistance | 3Ohm |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Max Power Dissipation | 450mW |
| Number of Circuits | 4 |
| Max Supply Voltage | 12V |
| Min Supply Voltage | 2.7V |
| Max Supply Current | 1μA |
| Turn On Delay Time | 57 ns |
| Voltage - Supply, Single/Dual (±) | 3V~16V ±3V~8V |
| Supply Type | Dual, Single |
| Turn-Off Delay Time | 42 ns |
| Max Dual Supply Voltage | 6V |
| On-State Resistance (Max) | 3Ohm |
| Min Dual Supply Voltage | 3V |
| Multiplexer/Demultiplexer Circuit | 1:1 |
| Current - Leakage (IS(off)) (Max) | 1nA |
| Channel Capacitance (CS(off), CD(off)) | 49pF 37pF |
| Switch Circuit | SPST - NO |
| Switch Time (Ton, Toff) (Max) | 51ns, 35ns |
| Charge Injection | 38pC |
| Crosstalk | -77dB @ 1MHz |
| Height | 920μm |
| Length | 5.08mm |
| Width | 4.4mm |
| RoHS Status | Non-RoHS Compliant |
DG9424DQ-T1 Overview
Shipping overseas is convenient with the electronic component packed in 16-TSSOP (0.173, 4.40mm Width). This packaging method provides high reliability because it uses advanced packaging techniques. In Surface Mount, this analog switch is mounted. The ratio between the number of multiplexer and demultiplexer circuits is 1:1. Temperatures around -40°C~85°C TA are extended for operation. Unlike digital switches, these are based on SPST - NO switching circuits. Circuits number 4 make up this analogue multiplexer. There is 3Ohm internal resistance in this digital multiplexer. For details about the functions of 16 pins, please refer to the datasheets. It is generally not recommended to supply a voltage higher than 12V to the switch device in normal circumstances. The digital multiplexer has a low cost Dual, Single supply. 2.7V should be the lowest voltage fed to the electronic component. The switch multiplexer may be damaged if it is exposed to voltage greater than 1μA. Despite this switch device's dual supply capability, its voltage should not exceed 6V. The voltage should be at least 3V if you are using dual power supplies. In an environment with a temperature higher than 85°C, the digital switches should not operate. Suppliers offer the 16-TSSOP package.
DG9424DQ-T1 Features
Switch Circuit: SPST - NO
DG9424DQ-T1 Applications
There are a lot of Vishay Siliconix DG9424DQ-T1 Analog Switches & Multiplexers ICs applications.
- Cable Telephony – NIU, Set-Top Box, Home Side Box
- Signal routing between systems
- Video signal routing
- Microprocessor controlled systems
- High reliability control systems
- Audio and video routing
- Precision test equipment
- Audio/video switches
- Data switching
- Data Acquisition Systems
