DRV401AIDWPG4
| Parameters | |
|---|---|
| Package / Case | SOIC |
| Surface Mount | YES |
| Number of Pins | 20 |
| Weight | 506.605978mg |
| JESD-609 Code | e4 |
| Moisture Sensitivity Level (MSL) | 2 |
| Number of Terminations | 20 |
| ECCN Code | EAR99 |
| Terminal Finish | Nickel/Palladium/Gold (Ni/Pd/Au) |
| Max Operating Temperature | 125°C |
| Min Operating Temperature | -40°C |
| HTS Code | 8542.39.00.01 |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Terminal Pitch | 1.27mm |
| Pin Count | 20 |
| Output Type | Analog |
| Operating Supply Voltage | 5V |
| Temperature Grade | AUTOMOTIVE |
| Number of Channels | 4 |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 4.5V |
| Operating Supply Current | 6.8mA |
| Slew Rate | 6.5 V/μs |
| Bandwidth | 2MHz |
| Height | 2.55mm |
| Length | 12.82mm |
| Width | 7.52mm |
| Radiation Hardening | No |
| REACH SVHC | No SVHC |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
DRV401AIDWPG4 Overview
The linear amplifier is packaged in a SOIC case. A total of 20 terminations have been reported in the past few weeks. There are a total of 20 pins on this op amp. The linear amplifier should be run at 5V at all times, so please keep that in mind when using it. 20 pins are located on the operational amplifiers. It is possible to operate this buffer amplifier from a supply current of 6.8mA . There are a total of 4 channels available on the op amps. One of the advantages of this op amp is that it outputs Analog signals, which is one of its many advantages. In order for op amp to function properly, the temperature should not be lower than -40°C degrees Celsius. You should only use op amp buffer at temperatures that are no higher than 125°C. The operating supply voltage of instrumentation amplifier is rated 5V voltage. When it comes to the voltage from which this electrical part will operate, it can operate at a maximum of less than 5.5V. It is recommended that you keep the instrumentation amplifier's supply voltage higher than 4.5V when using it.
DRV401AIDWPG4 Features
20 Pins
supply voltage of 5V
Output Type: Analog
DRV401AIDWPG4 Applications
There are a lot of Texas Instruments DRV401AIDWPG4 Instrumentational OP Amps applications.
- earphone
- Weak signal detection
- High/low-pass filter circuit
- Differentiator circuits
- Proportional operation circuits
- Instrumentation
- Wireless base stations
- Video conversion and routing
- Semiconductor detectors
- Medical imaging
