DRV8803PWP
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Lifecycle Status | ACTIVE (Last Updated: 2 days ago) |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 16-PowerTSSOP (0.173, 4.40mm Width) |
| Number of Pins | 16 |
| Weight | 62.709145mg |
| Operating Temperature | -40°C~150°C TJ |
| Packaging | Tube |
| JESD-609 Code | e4 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 3 (168 Hours) |
| Number of Terminations | 16 |
| ECCN Code | EAR99 |
| Terminal Finish | Nickel/Palladium/Gold (Ni/Pd/Au) |
| Applications | General Purpose |
| Technology | Power MOSFET |
| Voltage - Supply | 8.2V~60V |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Supply Voltage | 24V |
| Base Part Number | DRV8803 |
| Function | Driver - Fully Integrated, Control and Power Stage |
| Number of Outputs | 4 |
| Supply Voltage-Max (Vsup) | 60V |
| Supply Voltage-Min (Vsup) | 8.2V |
| Interface | Parallel |
| Operating Supply Current | 1.6mA |
| Output Configuration | Low Side (4) |
| Current - Output | 1A |
| Logic Function | AND |
| Supply Current-Max (Isup) | 2.1mA |
| Voltage - Load | 8.2V~60V |
| Motor Type | Stepper |
| Motor Type - AC, DC | Brushed DC |
| Motor Type - Stepper | Unipolar |
| Height | 1.2mm |
| Length | 5mm |
| Width | 4.4mm |
| Thickness | 1mm |
| Radiation Hardening | No |
| REACH SVHC | No SVHC |
| RoHS Status | ROHS3 Compliant |
| Lead Free | Lead Free |
DRV8803PWP Overview
Drivers controllers includes a Tubepackage.The part is packaged in a 16-PowerTSSOP (0.173, 4.40mm Width) case.Surface Mountshould be used for mounting the part.For the component connected to [0], it is suitable.The device can supply 8.2V~60V volts.In terms of operating temperature, it falls within the range -40°C~150°C TJ.There is a motor type Brushed DCavailable.A total of 16terminations are available in the part.The voltage can applied to the load at the rate of 8.2V~60V.You should run this amplifier at 24V.The recommended way to mount it is Surface Mount.Keep the part output current at 1A.This can be determined by looking at the DRV8803 part number.There are 16 pins on it.Drivers controllers is possible to access 4outputs.Stepperrepresents the motor type.Controller ic uses 1.6mAas the supply current for Controller ics operation.
DRV8803PWP Features
Applications : General Purpose
Load voltage across the chip 8.2V~60V
base on DRV8803 number
designed with 4 outputs
Motor Type classified as Stepper
DRV8803PWP Applications
There are a lot of Texas Instruments DRV8803PWP motor drivers applications.
- LED bias
- Landscape lighting
- Accurate LED current matching
- Alternative to HID lights
- Human-centric lighting
- AM radio
- Display LED backlighting
- Tail lights
- Step-up or step-down driver topologies
- Architectural lighting
