banner_page

DS1818R-5+T&R

DS1818 Voltage supervisorEconoReset Series Min 1V Max 5.5V


  • Manufacturer: Maxim Integrated
  • Nocochips NO: 503-DS1818R-5+T&R
  • Package: TO-236-3, SC-59, SOT-23-3
  • Datasheet: PDF
  • Stock: 757
  • Description: DS1818 Voltage supervisorEconoReset Series Min 1V Max 5.5V (Kg)

Details

Tags

Parameters
Factory Lead Time 1 Week
Mount Surface Mount
Mounting Type Surface Mount
Package / Case TO-236-3, SC-59, SOT-23-3
Number of Pins 3
Supplier Device Package SOT-23-3
Operating Temperature -40°C~85°C TA
Packaging Tape & Reel (TR)
Published 2011
Series EconoReset
Part Status Active
Moisture Sensitivity Level (MSL) 1 (Unlimited)
Type Simple Reset/Power-On Reset
Max Operating Temperature 85°C
Min Operating Temperature -40°C
Base Part Number DS1818
Output Open Drain or Open Collector
Number of Outputs 1
Max Supply Voltage 5.5V
Min Supply Voltage 1V
Operating Supply Current 28μA
Nominal Supply Current 28μA
Output Current 10mA
Max Supply Current 35μA
Watchdog Timer No
Reset Active Low
Voltage - Threshold 3.06V
Number of Voltages Monitored 1
Reset Timeout 100ms Minimum
Min Reset Threshold Voltage 2.98V
Max Reset Threshold Voltage 3.15V
Undervoltage Threshold 2.98V
Overvoltage Threshold 3.15V
Height 1.12mm
Length 3.04mm
Width 1.4mm
Radiation Hardening No
REACH SVHC Unknown
RoHS Status ROHS3 Compliant
Lead Free Lead Free

DS1818R-5+T&R Overview


A Tape & Reel (TR) package is used to package the power management. In this IC management you will find TO-236-3, SC-59, SOT-23-3 functions for you to refer to. This IC power shares lots of benefits with other Simple Reset/Power-On Reset products. Power ics operate at 1 supply voltages. The mount is attached to Surface Mount. Pin count of the power management is 3. I should note that the minimum supply voltage (Vsup) for this IC management should be at least 1V, which is the minimum supply voltage that should be applied. In this PMIC, the maximum supply voltage (Vsup) should not exceed 5.5V volts. A Surface Mount mounting type is recommended. The supervisors should be set to the following temperature: -40°C~85°C TA. During normal operation, this power managment ic can generate Open Drain or Open Collector of output voltage. There is a supply current of 28μA for the power management. If you want to search for similar IC managements of this manufacturer, you can always refer to DS1818, which is the base power ics number. The maximum supply temperature is 35μA. A PMIC from the well-known EconoReset series of products is being offered here. The architecture of this IC management supports 1 outputs.

DS1818R-5+T&R Features


Simple Reset/Power-On Reset type
Minimum supply voltage of 1V
28μA operating supply current

DS1818R-5+T&R Applications


There are a lot of Maxim Integrated DS1818R-5+T&R Voltage Supervisors applications.

  • Battery cars
  • WiFi router
  • Precision measurement
  • Battery-powered equipment
  • Power distribution systems of infant care room
  • Analog circuit
  • Refrigeration
  • Kitchen appliances
  • Automotive permanent magnet synchronous motors
  • Telecommunications equipment

Write a review

Note: HTML is not translated!
    Bad           Good