DS2118MB
| Parameters | |
|---|---|
| Terminal Pitch | 0.8mm |
| Reach Compliance Code | not_compliant |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| Base Part Number | DS2118M |
| Pin Count | 36 |
| JESD-30 Code | R-PDSO-G36 |
| Qualification Status | Not Qualified |
| Power Supplies | 5V |
| Differential Output | YES |
| Number of Signal Lines | 9 |
| Pull-up Resistance-Nom | 110Ohm |
| Height Seated (Max) | 2.64mm |
| Length | 15.375mm |
| Width | 7.5mm |
| RoHS Status | Non-RoHS Compliant |
| Lead Free | Contains Lead |
| Mounting Type | Surface Mount |
| Package / Case | 36-BSOP (0.295, 7.50mm Width) |
| Surface Mount | YES |
| Operating Temperature | 0°C~70°C |
| Packaging | Tube |
| Published | 1998 |
| JESD-609 Code | e0 |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 9 |
| Type | SCSI, LVD, SE |
| Terminal Finish | Tin/Lead (Sn/Pb) |
| Additional Feature | SINGLE ENDED TERMINATION REQUIRES 4V TO 5.5V SUPPLY |
| Subcategory | Bus Terminators |
| Technology | CMOS |
| Voltage - Supply | 4V~5.5V |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 245 |
| Number of Functions | 1 |
| Supply Voltage | 5V |
DS2118MB Overview
A 9 termination consists of terminating transmission lines with a device matching the line's characteristic impedance. The 36-BSOP (0.295, 7.50mm Width) is well known in the electronic industry due to its low package cost. The Packaging follows Tube's materials. Using Surface Mount, you mount it on a PCB. A temperature greater than 0°C~70°C should not be used as the operating temperature. SCSI, LVD, SE-qualified material suitable for standard applications. In order to ensure normal operation, 4V~5.5V Supply Voltage is provided. It is possible to find related parts using Base Part Number DS2118M. A specific purpose is served by the 36 pins. In terms of 9 signal lines, these are lines devoted exclusively to the transmission of signals or intelligence, either public or private. Keeping the supply voltage at 5V is essential for high efficiency. This falls under Subcategory Bus Terminators. In order to operate, 5V Power Supplies are required. For example, SINGLE ENDED TERMINATION REQUIRES 4V TO 5.5V SUPPLY is included among the additions.
DS2118MB Features
9 terminations
Tube package
DS2118M family
36 pin count
9 signal lines
5V power supplies
DS2118MB Applications
There are a lot of Maxim Integrated DS2118MB Signal Terminators applications.
- CSU and DSU
- Data Networking
- Desktop PCs
- tape drives
- High speed protected termination for digital input with serialized SPI output
- Disk array (RAID)
- IEC61131-2 type 1, 2 and 3
- Programmable logic controller
- Programmable logic controller and remote input modules
- Data Networking
