banner_page

EL5204IYZ

2 Channels 160mA per Channel 8μA 62 dB Instrumentational OP Amps 12V 10 Pins MSOP


  • Manufacturer: Intersil (Renesas Electronics America)
  • Nocochips NO: 391-EL5204IYZ
  • Package: MSOP
  • Datasheet: PDF
  • Stock: 439
  • Description: 2 Channels 160mA per Channel 8μA 62 dB Instrumentational OP Amps 12V 10 Pins MSOP(Kg)

Details

Tags

Parameters
Number of Terminations 10
ECCN Code EAR99
Terminal Finish Matte Tin (Sn) - annealed
Max Operating Temperature 85°C
Min Operating Temperature -40°C
Terminal Position DUAL
Terminal Form GULL WING
Peak Reflow Temperature (Cel) 260
Number of Functions 2
Terminal Pitch 0.5mm
Time@Peak Reflow Temperature-Max (s) 30
Pin Count 10
Operating Supply Voltage 12V
Temperature Grade INDUSTRIAL
Number of Channels 2
Max Supply Voltage 10V
Min Supply Voltage 4V
Operating Supply Current 9.5mA
Nominal Supply Current 22mA
Slew Rate 3000 V/μs
Common Mode Rejection Ratio 62 dB
Current - Input Bias 8μA
Output Current per Channel 160mA
Input Offset Voltage (Vos) 3mV
Bandwidth 700000 kHz
Voltage Gain 65dB
Power Supply Rejection Ratio (PSRR) 70dB
Max Dual Supply Voltage 6.6V
-3db Bandwidth 700MHz
Min Dual Supply Voltage 2V
Consumer IC Type VIDEO AMPLIFIER
Height Seated (Max) 1.1mm
Length 3mm
Radiation Hardening No
RoHS Status RoHS Compliant
Lead Free Lead Free
Factory Lead Time 1 Week
Mount Surface Mount
Package / Case MSOP
Number of Pins 10
Published 2003
JESD-609 Code e3
Part Status Active
Moisture Sensitivity Level (MSL) 2

EL5204IYZ Overview


Packaged in a MSOP case, the buffer op amp is ready to use. The number of terminations approaches 10. In this case, there are 10 pins on the board. The buffer op amp includes 10 pins. Regarding input offset voltage, buffer amplifier rates 3mV voltage. Using an 9.5mA supply current, this operational amplifier ics can be operated. Voltage gain should remain at 65dB. Op amp ic has 2 channels. For the buffer op amp to operate properly, it must be above the temperature of -40°C degrees Celsius. Instrumentation amplifier shouldn't be used above 85°C . The operating supply voltage of instrumentation amplifier is rated 12V voltage. Under 10V is the minimum supply voltage for this electric component. A high supply voltage of more than 4V is recommended for the instrumentation amplifier's supply voltage. This electronic part should be conducted with a dual supply voltage of 6.6V volts for this part. In order to sort the op amp's consumer IC type, VIDEO AMPLIFIER can be used.

EL5204IYZ Features


10 Pins
65dB voltage gain

EL5204IYZ Applications


There are a lot of Intersil (Renesas Electronics America) EL5204IYZ Instrumentational OP Amps applications.

  • Thermocouples
  • Portable electronic products powered by batteries
  • High-frequency data acquisition systems
  • Fast A/D and D/A converters
  • Blood pressure sensors
  • single/dual op amp sum and difference circuits
  • Proportional counter tubes
  • Wireless base stations
  • Multiplication circuits
  • Vehicle electronics

Write a review

Note: HTML is not translated!
    Bad           Good