EL8201ISZ
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Package / Case | SOIC |
| Number of Pins | 8 |
| Published | 2002 |
| JESD-609 Code | e3 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 3 |
| Number of Terminations | 8 |
| ECCN Code | EAR99 |
| Terminal Finish | Matte Tin (Sn) - annealed |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 2 |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Pin Count | 8 |
| Operating Supply Voltage | 5V |
| Temperature Grade | INDUSTRIAL |
| Number of Channels | 1 |
| Number of Circuits | 2 |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 3V |
| Operating Supply Current | 2mA |
| Nominal Supply Current | 2.4mA |
| Slew Rate | 200 V/μs |
| Common Mode Rejection Ratio | 90 dB |
| Current - Input Bias | 1.6μA |
| Output Current per Channel | 65mA |
| Input Offset Voltage (Vos) | 800μV |
| Bandwidth | 200000 kHz |
| Gain Bandwidth Product | 100MHz |
| Voltage Gain | 90dB |
| Power Supply Rejection Ratio (PSRR) | 100dB |
| Gain | 1 dB |
| -3db Bandwidth | 200MHz |
| Consumer IC Type | VIDEO AMPLIFIER |
| Height | 1.5mm |
| Length | 5mm |
| Width | 4mm |
| Radiation Hardening | No |
| REACH SVHC | No SVHC |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
EL8201ISZ Overview
There is a SOIC case package that contains the instrumentation amplifiers. It is estimated that there will be at least 8 terminations this year. In total, there are 8 pins on this op amp ic. Linear amplifier includes 8 pins. Op amp ic rates 800μV for input offset voltage. In order for this instrumentation amplifier to operate, the supply current needs to be between 2mA and 10 . There should be no change in the voltage gain. There are 2 circuits on op amps. The op amp ic has 1 channels on it. In order for op amp to function properly, the temperature should not be lower than -40°C degrees Celsius. You should only use op amp buffer at temperatures that are no higher than 85°C. The operating supply voltage of instrumentation amplifier is rated 5V voltage. In terms of the supply voltage, this electrical part is capable of operating at low voltage levels of under 5.5V. It is recommended that you keep the instrumentation amplifier's supply voltage higher than 3V when using it. VIDEO AMPLIFIER can be used to sort the linear amplifier based on its consumer IC type.
EL8201ISZ Features
8 Pins
90dB voltage gain
EL8201ISZ Applications
There are a lot of Intersil (Renesas Electronics America) EL8201ISZ Instrumentational OP Amps applications.
- Laptop
- Mobile phone
- Navigation
- Inverse/same-phase proportional circuit
- Thermocouples
- Precision measurement
- Voltage regulation circuit
- RF cable systems
- Comparator
- Test and measurement instruments
