EPM7032TC44-6
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Package / Case | TQFP |
| Number of Pins | 44 |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Part Status | Discontinued |
| Moisture Sensitivity Level (MSL) | 3 |
| Number of Terminations | 44 |
| Terminal Finish | Tin/Lead (Sn/Pb) |
| Max Operating Temperature | 70°C |
| Min Operating Temperature | 0°C |
| Subcategory | Programmable Logic Devices |
| Technology | CMOS |
| Terminal Position | QUAD |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 235 |
| Supply Voltage | 5V |
| Terminal Pitch | 0.8mm |
| Frequency | 200MHz |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Pin Count | 44 |
| Qualification Status | Not Qualified |
| Operating Supply Voltage | 5V |
| Power Supplies | 5V |
| Temperature Grade | COMMERCIAL |
| Max Supply Voltage | 5.25V |
| Min Supply Voltage | 4.75V |
| Number of I/O | 36 |
| Memory Type | EEPROM |
| Propagation Delay | 6 ns |
| Programmable Logic Type | EE PLD |
| Number of Gates | 600 |
| Number of Logic Blocks (LABs) | 2 |
| Output Function | MACROCELL |
| Number of Macro Cells | 32 |
| JTAG BST | NO |
| In-System Programmable | NO |
| Length | 10mm |
| Width | 10mm |
| RoHS Status | RoHS Compliant |
EPM7032TC44-6 Overview
There are 32 macro cells. A macro cell is a cell in a mobile phone network that provides radio coverage through the use of a high-power cell site (tower, antenna or mast).It is part of the TQFP package.This device has 36 I/O ports programmed into it.It is programmed to terminate devices at [0].The terminal position of this electrical component is QUAD.Power is supplied by a voltage of 5V volts.It is included in Programmable Logic Devices.In this chip, the 44pins are programmed.The 600gates serve as building blocks for digital circuits.The supply voltage should be maintained at 5V for high efficiency.For data storage, EEPROMis adopted.Surface Mountis the mounting point of this electronic part.The device is designed with pins [0].In this case, the maximum supply voltage is 5.25V.With a minimal supply voltage of [0], it operates.A power supply of 5Vvolts is required to operate this device.You can achieve 200MHzfrequencies.There should be a temperature above 0°Cat the time of operation.A temperature lower than 70°Cis recommended for operation.There are 2logic blocks (LABs) that make up its basic building block.It is possible to classify programmable logic as EE PLD.
EPM7032TC44-6 Features
TQFP package
36 I/Os
44 pin count
44 pins
5V power supplies
2 logic blocks (LABs)
EPM7032TC44-6 Applications
There are a lot of Altera EPM7032TC44-6 CPLDs applications.
- Address decoding
- TIMERS/COUNTERS
- STANDARD SERIAL INTERFACE UART
- Digital designs
- POWER-SAVING MODES
- Preset swapping
- Programmable polarity
- Auxiliary Power Supply Isolated and Non-isolated
- Programmable power management
- Pattern recognition
