FAH4820MPX
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 10-WFDFN Exposed Pad |
| Number of Pins | 10 |
| Weight | 25mg |
| Operating Temperature | -40°C~150°C TJ |
| Packaging | Tape & Reel (TR) |
| JESD-609 Code | e4 |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 10 |
| ECCN Code | EAR99 |
| Terminal Finish | Nickel/Palladium/Gold (Ni/Pd/Au) |
| Applications | Haptic Feedback |
| Subcategory | Motion Control Electronics |
| Technology | Power MOSFET |
| Voltage - Supply | 2.7V~5.5V |
| Terminal Position | DUAL |
| Supply Voltage | 3.3V |
| Terminal Pitch | 0.5mm |
| Base Part Number | FAH4820 |
| Function | Driver - Fully Integrated, Control and Power Stage |
| Number of Outputs | 1 |
| Output Voltage | 200mV |
| Supply Voltage-Max (Vsup) | 5.5V |
| Supply Voltage-Min (Vsup) | 2.7V |
| Interface | I2C |
| Analog IC - Other Type | BRUSH DC MOTOR CONTROLLER |
| Nominal Supply Current | 5mA |
| Output Configuration | Differential |
| Current - Output | 275mA |
| Logic Function | AND |
| Collector Emitter Voltage (VCEO) | 3V |
| Max Collector Current | 500mA |
| Voltage - Load | 2.4V~3.6V |
| Switching Frequency | 400kHz |
| Motor Type - AC, DC | ERM |
| Height | 750μm |
| Length | 3mm |
| Width | 3mm |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
FAH4820MPX Overview
The package is designed with [0].This part is packaged with a case of [0].Ideally, the part should be mounted by Surface Mount.I believe it would be suitable for the component connected to Haptic Feedback.This device is capable of supplying voltages up to 2.7V~5.5V volts.Regarding the operating temperature, it is in the range of -40°C~150°C TJ°C.There is a motor type ERMavailable.A total of 10terminations are available in the part.At a rate of [0], voltage can be applied to the load.Please take in mind that this amplifier should be run at 3.3V.Ideally, it should be mounted in the Surface Mountposition.Set the part's output current to 275mA.A BRUSH DC MOTOR CONTROLLERanalog integrated circuit is employed in the device.Using the FAH4820part number, it is located.10 pins are provided for its design.This is part of the Motion Control Electronics series.The available outputs are [0].In this case, 200mVis maintained as the output voltage.
FAH4820MPX Features
Applications : Haptic Feedback
Load voltage across the chip 2.4V~3.6V
base on FAH4820 number
designed with 1 outputs
FAH4820MPX Applications
There are a lot of ON Semiconductor FAH4820MPX motor drivers applications.
- Fog lamps
- Emergency lighting
- Scanning equipment
- AM radio
- drivers for outdoor application
- Dash
- Outdoor area lights
- Multiple output capability
- LED bias
- Arena lighting
