FSA2257MUX
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Lifecycle Status | ACTIVE (Last Updated: 2 days ago) |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 10-TFSOP, 10-MSOP (0.118, 3.00mm Width) |
| Number of Pins | 10 |
| Weight | 112.5mg |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tape & Reel (TR) |
| Published | 2004 |
| JESD-609 Code | e4 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 10 |
| Termination | SMD/SMT |
| ECCN Code | EAR99 |
| Resistance | 1.5Ohm |
| Terminal Finish | Nickel/Palladium/Gold (Ni/Pd/Au) |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Number of Functions | 2 |
| Supply Voltage | 2.7V |
| Terminal Pitch | 0.5mm |
| Base Part Number | FSA2257 |
| Number of Outputs | 4 |
| Power Supplies | 1.8/5V |
| Number of Channels | 1 |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 1.65V |
| Nominal Supply Current | 100nA |
| Max Supply Current | 500nA |
| Turn On Delay Time | 35 ns |
| Number of Inputs | 2 |
| Supply Type | Single |
| Bandwidth | 350MHz |
| Turn-Off Delay Time | 15 ns |
| -3db Bandwidth | 200MHz |
| On-State Resistance (Max) | 1.5Ohm Typ |
| Multiplexer/Demultiplexer Circuit | 2:1 |
| Off-state Isolation-Nom | 70 dB |
| Current - Leakage (IS(off)) (Max) | 2nA |
| Channel Capacitance (CS(off), CD(off)) | 12pF |
| On-state Resistance Match-Nom | 0.7Ohm |
| Switch Circuit | SPDT |
| Switch Time (Ton, Toff) (Max) | 35ns, 15ns |
| Charge Injection | 10pC |
| Channel-to-Channel Matching (ΔRon) | 700m Ω |
| Crosstalk | -75dB @ 1MHz |
| Switching | BREAK-BEFORE-MAKE |
| Switch-on Time-Max | 50ns |
| Voltage - Supply, Single (V+) | 1.65V~5.5V |
| Height | 850μm |
| Length | 3mm |
| Width | 3mm |
| Radiation Hardening | No |
| REACH SVHC | No SVHC |
| RoHS Status | ROHS3 Compliant |
| Lead Free | Lead Free |
FSA2257MUX Overview
This electronic part is conveniently packaged in 10-TFSOP, 10-MSOP (0.118, 3.00mm Width), making it easy to ship abroad. This packaging method provides high reliability because it uses advanced packaging techniques. In Surface Mount, you'll find this switch device. Multiplexers and demultiplexers have a number of circuits 2:1. The operating temperature is extended to around -40°C~85°C TA. In total, 10 terminations have occurred. This electronic part offers high-quality output due to its 1 channels. When a voltage supply of 2.7V is used, the electronic component should be turned on and run. SPDT switching circuits are used in these analog switch ics. Try searching for the analog switch ic with FSA2257 if you are looking for variants. A 1.5Ohm internal resistance characterizes this multiplexer. Datasheets for 10 pin functions are available upon request. Theswitch device is a typical Multiplexer or Switches. An abnormal situation would be for the switch device to be supplied with a voltage greater than 5.5V. An effective Single supply digital multiplexer. 1.65V is the lowest voltage the electrical component should receive. A voltage of 1.65V~5.5V is required for this switch device, which drains from a single voltage source. A voltage higher than 500nA may cause damage to the switch multiplexer. It is possible to operate 2 inputs. There are 350MHz bandwidths for data transfer. Multiplexer ics with 4 outputs are available.
FSA2257MUX Features
1 Channels
Switch Circuit: SPDT
-3db Bandwidth: 200MHz
Bandwidth: 350MHz
FSA2257MUX Applications
There are a lot of ON Semiconductor FSA2257MUX Analog Switches & Multiplexers ICs applications.
- Avionics
- Cell phones
- Audio/video switches
- Central office
- Digital access cross connects
- Voice over IP/DSL – Integrated Access Devices, Smart
- Wireless Local Loop
- Public switching systems
- Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
- Microprocessor Controlled Analog Systems
