FT3001UMX
| Parameters | |
|---|---|
| Terminal Finish | Nickel/Palladium/Gold (Ni/Pd/Au) |
| Max Power Dissipation | 5mW |
| Technology | CMOS |
| Terminal Position | QUAD |
| Supply Voltage | 3V |
| Base Part Number | FT3001 |
| Output | Open Drain, Push-Pull |
| JESD-30 Code | R-XQCC-N |
| Max Supply Voltage | 5V |
| Min Supply Voltage | 1.8V |
| Operating Supply Current | 100μA |
| Power Dissipation | 5mW |
| Propagation Delay | 7.2 s |
| Quiescent Current | 1μA |
| Reset | Active High/Active Low |
| Reset Timeout | 400ms Typical |
| Supply Type | Single |
| Number of Timers/Counters | 4 |
| High Level Output Current | -100μA |
| Low Level Output Current | 500μA |
| Information Access Method | SERIAL, 2-WIRE/I2C |
| Height | 500μm |
| Length | 1.4mm |
| Width | 1.8mm |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
| Factory Lead Time | 1 Week |
| Lifecycle Status | ACTIVE (Last Updated: 4 days ago) |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 10-UFQFN |
| Number of Pins | 10 |
| Weight | 18.08g |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Cut Tape (CT) |
| Published | 2012 |
| JESD-609 Code | e4 |
| Pbfree Code | yes |
| Part Status | Discontinued |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| ECCN Code | EAR99 |
| Type | Reset Timer |
FT3001UMX Overview
There is a Cut Tape (CT)-packaging method applied to IC management. In this PMIC, you can find 10-UFQFN functions for your reference. It is a IC power that shares many benefits with other products from the Reset Timer line. When 3V is applied to the power ic, it conducts. Power management is included in the Surface Mount mount. This power management has 10 pins. Supply voltage (Vsup) should be at least 1.8V for this power management. There should be no more than 5V volts of supply voltage (Vsup) in this power management. Power management recommends the Surface Mount mounting type. It is recommended that the supervisor be set to this temperature: -40°C~85°C TA. As this power managment ic operates, it is able to produce an output voltage of Open Drain, Push-Pull. The power management's supply current is 100μA. You can always use FT3001, the base supervisor number, to search for similar PMICs of the manufacturer.
FT3001UMX Features
Reset Timer type
Minimum supply voltage of 1.8V
100μA operating supply current
FT3001UMX Applications
There are a lot of ON Semiconductor FT3001UMX Voltage Supervisors applications.
- Satellite navigation
- Detection of phase loss
- Power communication system
- Digitally controlled LDO regulators circuit
- Smartphones
- Solar power charger
- Embedded computing
- Military communications
- Electronics installed in the vehicle
- Leakage protection
