HA1630Q06TELL-E
| Parameters | |
|---|---|
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 14 |
| Subcategory | Operational Amplifier |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Number of Functions | 4 |
| Supply Voltage | 3V |
| Terminal Pitch | 0.65mm |
| Base Part Number | HA1630Q |
| Pin Count | 14 |
| Number of Circuits | 4 |
| Operating Supply Current | 3.2mA |
| Slew Rate | 8V/μs |
| Amplifier Type | General Purpose |
| Common Mode Rejection Ratio | 70 dB |
| Current - Input Bias | 1pA |
| Voltage - Supply, Single/Dual (±) | 1.8V~5.5V |
| Output Current per Channel | 6.5mA |
| Input Offset Voltage (Vos) | 4mV |
| Gain Bandwidth Product | 3.6MHz |
| Unity Gain BW-Nom | 3600 kHz |
| Supply Voltage Limit-Max | 7V |
| Height Seated (Max) | 1.1mm |
| Length | 5mm |
| RoHS Status | ROHS3 Compliant |
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 14-TSSOP (0.173, 4.40mm Width) |
| Number of Pins | 8 |
| Operating Temperature | -40°C~85°C |
| Packaging | Tape & Reel (TR) |
| Published | 2006 |
HA1630Q06TELL-E Overview
Packaged in a 14-TSSOP (0.173, 4.40mm Width) case, the buffer op amp is ready to use. A General Purpose-type buffer amplifier is shown here. There is a Tape & Reel (TR) case that is delivered with the instrumentation amplifiers. We are approaching the 14h termination of the year. The pins on this board total to 14 in total. As a reminder, this buffer op amp should be powered by 3V battery and that the battery should be inserted in the amplifier. There are two types of Operational Amplifier op amps in this case, and this device falls into one of them. There are 8 pins on this chip. In terms of input offset voltage, operational amplifier rates 4mV. For this electronic part, it is recommended that you mount it with type Surface Mount. It is recommended that this op amp ic be operated at a temperature no higher than -40°C~85°C for optimal performance. An 3.2mA volt supply current is needed for this linear amplifier to operate. This op amp contains 4 circuits.
HA1630Q06TELL-E Features
14 Pins
supply voltage of 3V
HA1630Q06TELL-E Applications
There are a lot of Renesas Electronics America HA1630Q06TELL-E Instrumentational OP Amps applications.
- Portable electronic products powered by batteries
- single/dual op amp sum and difference circuits
- Navigation
- Division circuits
- Semiconductor detectors
- Signal transformation
- Large motor controllers
- Proportional counter tubes
- Differentiator circuits
- Scintillation detectors
