HCPL-7510-500E
| Parameters | |
|---|---|
| Number of Channels | 1 |
| Number of Circuits | 1 |
| Analog IC - Other Type | ANALOG CIRCUIT |
| Operating Supply Current | 11.7mA |
| Nominal Supply Current | 16mA |
| Amplifier Type | Isolation |
| Common Mode Rejection Ratio | 63 dB |
| Current - Input Bias | 600nA |
| Voltage - Supply, Single/Dual (±) | 4.5V~5.5V |
| Output Current per Channel | 16mA |
| Input Offset Voltage (Vos) | 600μV |
| Bandwidth | 100 kHz |
| Input Current | 11.7mA |
| Isolation Voltage | 3.75kV |
| Height Seated (Max) | 4.455mm |
| Radiation Hardening | No |
| REACH SVHC | No SVHC |
| RoHS Status | ROHS3 Compliant |
| Lead Free | Lead Free |
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 8-SMD, Gull Wing |
| Number of Pins | 8 |
| Operating Temperature | -40°C~85°C |
| Packaging | Tape & Reel (TR) |
| Published | 2004 |
| JESD-609 Code | e3 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 8 |
| ECCN Code | EAR99 |
| Terminal Finish | Matte Tin (Sn) |
| Terminal Position | DUAL |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Terminal Pitch | 2.54mm |
| Time@Peak Reflow Temperature-Max (s) | 40 |
| Base Part Number | HCPL-7510 |
| Output Voltage | 5.5V |
| Supply Voltage-Min (Vsup) | 4.5V |
HCPL-7510-500E Overview
In the package, you will find a 8-SMD, Gull Wing-case to contain the op amp ic. There are two types of operational amplifiers in this circuit. Linear amplifier is delivered in a Tape & Reel (TR) case. During the past two weeks, there have been close to 8 terminations. It would be helpful if you could remember that this op amp ic should be powered by an 5V battery. There are 8 pins on this chip. In terms of the input offset voltage, instrumentation amplifier rates at 600μV. Surface Mount is the recommended mounting type of operational amplifiers. Regarding the operating temperature of this device, instrumentation amplifier performs well at a temperature of -40°C~85°C . You can run this op amp ic on 11.7mA . A instrumentation amplifier like this has 1 circuits. Buffer op amp is equipped with 1 channels on the device. An analog IC known as a ANALOG CIRCUIT is the other type of IC that is used in this op amp ic.
HCPL-7510-500E Features
supply voltage of 5V
HCPL-7510-500E Applications
There are a lot of Broadcom Limited HCPL-7510-500E Instrumentational OP Amps applications.
- Logarithmic operation circuits
- Image computer boards
- Car stereo
- Mobile phone
- Portable media players
- Industrial control system
- Video amplifiers
- Power generator
- Test and measurement instruments
- Signal transformation
