HCPL-7800A#500
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Contact Plating | Lead, Tin |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 8-SMD, Gull Wing |
| Number of Pins | 8 |
| Operating Temperature | -40°C~85°C |
| Packaging | Tape & Reel (TR) |
| Published | 2008 |
| JESD-609 Code | e0 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 8 |
| ECCN Code | EAR99 |
| Terminal Finish | Tin/Lead (Sn/Pb) |
| Terminal Position | DUAL |
| Peak Reflow Temperature (Cel) | 245 |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Terminal Pitch | 2.54mm |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Base Part Number | HCPL-7800 |
| Operating Supply Voltage | 5V |
| Power Supplies | 5V |
| Number of Circuits | 1 |
| Operating Supply Current | 10.9mA |
| Nominal Supply Current | 16mA |
| Amplifier Type | Isolation |
| Common Mode Rejection Ratio | 76 dB |
| Current - Input Bias | 500nA |
| Voltage - Supply, Single/Dual (±) | 4.5V~5.5V |
| Output Current per Channel | 16mA |
| Input Offset Voltage (Vos) | 300μV |
| Bandwidth | 100 kHz |
| -3db Bandwidth | 100MHz |
| Isolation Voltage | 3.75kV |
| Voltage Gain-Min | 7.92 |
| Height Seated (Max) | 4.455mm |
| Radiation Hardening | No |
| RoHS Status | Non-RoHS Compliant |
| Lead Free | Contains Lead |
HCPL-7800A#500 Overview
Op amp is packaged in 8-SMD, Gull Wing case. Op amps are Isolation types of amplifier on the chip. As far as the packaging is concerned, buffer op amp is delivered in a Tape & Reel (TR) case. It is estimated that there will be at least 8 terminations this year. It is important to remember that this op amp should be operated at a voltage of 5V volts. An 8-pin op amp ic is included in the package. Op amp ic rates 300μV for input offset voltage. Surface Mount is the recommended mounting type of operational amplifiers. Regarding the operating temperature of this device, instrumentation amplifier performs well at a temperature of -40°C~85°C . A supply current of 10.9mA can be used to operate this linear amplifier. On this instrumentation amplifier, there are 1 circuits that are connected together. The operating supply voltage of instrumentation amplifier is rated 5V voltage. This op amp ic is capable of conducting at least 7.92 voltage gains.
HCPL-7800A#500 Features
supply voltage of 5V
HCPL-7800A#500 Applications
There are a lot of Broadcom Limited HCPL-7800A#500 Instrumentational OP Amps applications.
- Broadcasting
- Exponential operation circuits
- Medical instruments
- Portable docking station
- Ultrasound transducers
- Multiplication circuits
- Integrator circuits
- High/low-pass filter circuit
- Biopotential
- Signal operation
