HCPL-788J
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 16-SOIC (0.295, 7.50mm Width) |
| Number of Pins | 16 |
| Operating Temperature | -40°C~85°C |
| Packaging | Tube |
| Published | 2005 |
| JESD-609 Code | e0 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 16 |
| ECCN Code | EAR99 |
| Terminal Finish | Tin/Lead (Sn/Pb) |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Base Part Number | HCPL-788J |
| Output Voltage | 6V |
| Operating Supply Voltage | 5V |
| Power Supplies | 5V |
| Number of Circuits | 1 |
| Operating Supply Current | 20mA |
| Nominal Supply Current | 20mA |
| Amplifier Type | Isolation |
| Common Mode Rejection Ratio | 140 dB |
| Voltage - Supply, Single/Dual (±) | 4.5V~5.5V |
| Output Current per Channel | 20mA |
| Input Offset Voltage (Vos) | 3mV |
| Bandwidth | 30 kHz |
| Rise Time | 25μs |
| -3db Bandwidth | 30MHz |
| Input Current | 10.7mA |
| Isolation Voltage | 3.75kV |
| Voltage Gain-Min | 7.5397 |
| Voltage Gain-Max | 8.3333 |
| Radiation Hardening | No |
| RoHS Status | Non-RoHS Compliant |
| Lead Free | Contains Lead |
HCPL-788J Overview
There is a 16-SOIC (0.295, 7.50mm Width) case in which the instrumentation amplifier is packaged. There are two types of operational amplifiers in this circuit. It comes in a Tube case, which protects instrumentation amplifier from damage during delivery. It is estimated that there will be 16 terminations in the next few months. Please take in mind that this instrumentation amplifier should be run at 5V. 16 pins are located on the operational amplifiers. Regarding input offset voltage, buffer amplifier rates 3mV voltage. Surface Mount is the recommended mounting type of operational amplifiers. The buffer amplifier functions well at -40°C~85°C as far as operating temperature is concerned. You can run this op amp ic on 20mA . A linear amplifier like this has 1 circuits on it. The operating supply voltage of the buffer op amp is rated at 5V. There are a maximum of 7.5397 voltage gains that can be conducted by this operational amplifier at its minimum voltage gain.
HCPL-788J Features
supply voltage of 5V
HCPL-788J Applications
There are a lot of Broadcom Limited HCPL-788J Instrumentational OP Amps applications.
- Gaming industry
- Micro signal measurement
- Video conversion and routing
- Car stereo
- Vehicle electronics
- Comparator
- Television broadcasting equipment
- Non-polarized electrodes
- Mobile phone
- Tablets
