HI1-0201HS-2
| Parameters | |
|---|---|
| Number of Bits | 4 |
| Throw Configuration | SPST |
| Turn On Delay Time | 50 ns |
| Supply Type | Dual, Single |
| Neg Supply Voltage-Nom (Vsup) | -15V |
| Turn-Off Delay Time | 150 ns |
| Dual Supply Voltage | 15V |
| Off-state Isolation-Nom | 72 dB |
| On-state Resistance Match-Nom | 0.9Ohm |
| Switching | BREAK-BEFORE-MAKE |
| Drain to Source Resistance | 30Ohm |
| Normal Position | NC |
| Height Seated (Max) | 5.08mm |
| Width | 7.62mm |
| Radiation Hardening | No |
| REACH SVHC | No SVHC |
| RoHS Status | Non-RoHS Compliant |
| Lead Free | Contains Lead |
| Factory Lead Time | 1 Week |
| Mount | Through Hole |
| Package / Case | CDIP |
| Number of Pins | 16 |
| Packaging | Bulk |
| Published | 1999 |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Part Status | Active |
| Number of Terminations | 16 |
| ECCN Code | EAR99 |
| Resistance | 50Ohm |
| Terminal Finish | Tin/Lead (Sn/Pb) |
| Max Operating Temperature | 125°C |
| Min Operating Temperature | -55°C |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Number of Functions | 4 |
| Supply Voltage | 15V |
| Output | SEPARATE OUTPUT |
| Pin Count | 16 |
| Operating Supply Voltage | 15V |
| Temperature Grade | MILITARY |
| Number of Channels | 1 |
| Max Supply Voltage | 36V |
| Operating Supply Current | 4.5mA |
| Nominal Supply Current | 4.5mA |
| Max Supply Current | 10mA |
HI1-0201HS-2 Overview
Presented in CDIP, this electrical component is convenient for overseas shipping. To ensure high reliability, a new packaging method Bulk is used. Total terminations are 16. This electronic part offers high-quality output due to its 1 channels. When a voltage supply of 15V is used, the electronic component should be turned on and run. It is injected into the electrical part body with 16 pins. This digital multiplexer has 50Ohm internal resistance. You can find the functions of the 16 pins in the datasheets. In this analog multiplexer, the value is Multiplexer or Switches. In a normalsituation, users should not supply the switches with voltage higher than 36V. Analogue multiplexers of the Dual, Single supply type that are cost-effective. This multiplexer would work with 4.5mA current. Put voltage above 10mA on the multiplexer to cause damage. The outputs of this digital multiplexer are SEPARATE OUTPUT in number. 15V operating voltages can be used with this electrical part. The switches should not operate in an environment where the temperature is higher than 125°C. There is 30Ohm resistance between Drain and Source for this electronic part. 4-bits are supported.
HI1-0201HS-2 Features
1 Channels
4.5mA Supply Current
Drain-to-Source resistance: 30Ohm
4-Bit
HI1-0201HS-2 Applications
There are a lot of Intersil (Renesas Electronics America) HI1-0201HS-2 Analog Switches & Multiplexers ICs applications.
- High-Voltage
- Microprocessor Controlled Analog Systems
- USB 1.1 signal switching circuits
- Isolation
- Signal routing between systems
- Frame Relay Equipment
- PDAs
- Microprocessor controlled systems
- Multi-Line E1 Interface Cards
- Data switching
