HI1-0509-2
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mount | Through Hole |
| Package / Case | CDIP |
| Number of Pins | 16 |
| Packaging | Bulk |
| Published | 1999 |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Part Status | Active |
| Number of Terminations | 16 |
| ECCN Code | EAR99 |
| Resistance | 300Ohm |
| Terminal Finish | Tin/Lead (Sn/Pb) |
| Max Operating Temperature | 125°C |
| Min Operating Temperature | -55°C |
| Technology | CMOS |
| Number of Functions | 1 |
| Supply Voltage | 15V |
| Terminal Pitch | 2.54mm |
| Pin Count | 16 |
| Operating Supply Voltage | 15V |
| Temperature Grade | MILITARY |
| Number of Channels | 1 |
| Max Supply Voltage | 25V |
| Power Dissipation-Max | 51mW |
| Operating Supply Current | 1.5mA |
| Throw Configuration | 4PST |
| Turn On Delay Time | 500 ns |
| Logic Function | Multiplexer |
| Supply Type | Dual |
| Supply Current-Max (Isup) | 2.4mA |
| Neg Supply Voltage-Nom (Vsup) | -15V |
| Turn-Off Delay Time | 500 ns |
| Max Dual Supply Voltage | 22V |
| Min Dual Supply Voltage | 10V |
| Off-state Isolation-Nom | 68 dB |
| On-state Resistance Match-Nom | 9Ohm |
| Switching | BREAK-BEFORE-MAKE |
| Signal Current-Max | 0.02A |
| Height Seated (Max) | 5.08mm |
| Width | 7.62mm |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
| Lead Free | Contains Lead |
HI1-0509-2 Overview
The electrical component comes in CDIP packaging, which makes it convenient to ship overseas. In order to provide high reliability, an advanced packaging method Bulk is used. In total, there have been 16 terminations. As a result of its 1 channels, this electronic component provides high-quality output. When a voltage supply of 15V is used, the electronic component should be turned on and run. An injection of 16 pins is performed into the body of the electrical component. Analog switches have 300Ohm internal resistance. The functions of 16 pins can be found in the datasheets. In a normalsituation, users should not supply the switches with voltage higher than 25V. Analogue multiplexers of the Dual supply type that are cost-effective. The switch device would be able to operate with 1.5mA current. It is possible to supply this switch device with dual voltages. However, it is not advisable to exceed 22V. It is recommended that you attach at least 10V to your dual power supply. The electronic component can function from 15V. Temperatures above 125°C degrees Celsius should not be operated by the multiplexer.
HI1-0509-2 Features
1 Channels
1.5mA Supply Current
HI1-0509-2 Applications
There are a lot of Intersil (Renesas Electronics America) HI1-0509-2 Analog Switches & Multiplexers ICs applications.
- Digital cross connects (DSX-1)
- DSUs
- Public switching systems
- Avionics
- Cable PC
- PBX interfaces
- FTTH
- Audio signal routing
- Medical systems
- Communication systems
