banner_page

HI1-5051-5

Analog Switches BREAK-BEFORE-MAKE 16 Pins 15V CDIP


  • Manufacturer: Intersil (Renesas Electronics America)
  • Nocochips NO: 391-HI1-5051-5
  • Package: CDIP
  • Datasheet: PDF
  • Stock: 878
  • Description: Analog Switches BREAK-BEFORE-MAKE 16 Pins 15V CDIP(Kg)

Details

Tags

Parameters
Mount Through Hole
Package / Case CDIP
Number of Pins 16
Packaging Bulk
Published 1999
JESD-609 Code e0
Part Status Discontinued
Number of Terminations 16
Resistance 45Ohm
Terminal Finish Tin/Lead (Sn/Pb)
Max Operating Temperature 75°C
Min Operating Temperature 0°C
Subcategory Multiplexer or Switches
Technology CMOS
Peak Reflow Temperature (Cel) NOT SPECIFIED
Number of Functions 2
Supply Voltage 15V
Time@Peak Reflow Temperature-Max (s) NOT SPECIFIED
Output SEPARATE OUTPUT
Pin Count 16
Qualification Status Not Qualified
Power Supplies 5+-15V
Temperature Grade COMMERCIAL EXTENDED
Number of Channels 1
Operating Supply Current 300μA
Number of Bits 2
Throw Configuration SPDT
Turn On Delay Time 370 ns
Supply Type Dual
Neg Supply Voltage-Nom (Vsup) -15V
Turn-Off Delay Time 280 ns
Off-state Isolation-Nom 80 dB
On-state Resistance Match-Nom 1Ohm
Switching BREAK-BEFORE-MAKE
Switch-on Time-Max 500ns
Switch-off Time-Max 500ns
Drain to Source Resistance 25mOhm
Height Seated (Max) 5.08mm
RoHS Status RoHS Compliant
Lead Free Contains Lead

HI1-5051-5 Overview


Presented in CDIP, this electrical component is convenient for overseas shipping. High reliability is achieved by using advanced packaging method Bulk. In total, there have been 16 terminations. A high-quality output is provided by the electrical component's 1 channels. A 15V voltage supply should turn on and run the electronic component. A key feature of the 16 series is the inclusion of this electronic part as part of its design. The internal resistance of this digital multiplexer is 45Ohm. To find out what the functions of 16 pins are, please refer to their datasheets. A analogue multiplexer of this type is a Multiplexer or Switches. The digital multiplexer has a low cost Dual supply. For this multiplexer to operate, 300μA current would be sufficient. The analog switch ic utilizes SEPARATE OUTPUT outputs in total. In an environment with a temperature higher than 75°C, the digital switches should not operate. A Drain to Source resistance of 25mOhm is shown for this electronic part. It can conduct 2-bit signals.

HI1-5051-5 Features


1 Channels
300μA Supply Current
Drain-to-Source resistance: 25mOhm
2-Bit

HI1-5051-5 Applications


There are a lot of Intersil (Renesas Electronics America) HI1-5051-5 Analog Switches & Multiplexers ICs applications.

  • Relay replacements
  • Central office
  • Remote Powered Equipment
  • Power routing
  • High speed data transmission line cards
  • Video switching
  • Voice over IP/DSL – Integrated Access Devices, Smart
  • Existing multiplexer applications (both fault-protected and nonfault-protected)
  • Microprocessor controlled systems
  • Data Acquisition Systems

Write a review

Note: HTML is not translated!
    Bad           Good