HI3-0201-5
| Parameters | |
|---|---|
| Mounting Type | Through Hole |
| Package / Case | 16-DIP (0.300, 7.62mm) |
| Surface Mount | NO |
| Operating Temperature | 0°C~70°C TA |
| Packaging | Tube |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 3 (168 Hours) |
| Number of Terminations | 16 |
| Terminal Finish | TIN LEAD |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Position | DUAL |
| Peak Reflow Temperature (Cel) | NOT SPECIFIED |
| Number of Functions | 4 |
| Supply Voltage | 15V |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| Output | SEPARATE OUTPUT |
| Pin Count | 16 |
| JESD-30 Code | R-PDIP-T16 |
| Qualification Status | Not Qualified |
| Power Supplies | +-15V |
| Number of Channels | 1 |
| Number of Circuits | 4 |
| Voltage - Supply, Single/Dual (±) | 5V~30V ±4.5V~18V |
| Neg Supply Voltage-Nom (Vsup) | -15V |
| On-State Resistance (Max) | 80Ohm |
| Multiplexer/Demultiplexer Circuit | 1:1 |
| Off-state Isolation-Nom | 80 dB |
| Current - Leakage (IS(off)) (Max) | 10nA |
| Channel Capacitance (CS(off), CD(off)) | 5pF 5pF |
| Switch Circuit | SPST - NC |
| Switch Time (Ton, Toff) (Max) | 500ns, 350ns |
| Charge Injection | 20pC |
| Crosstalk | -90dB @ 100kHz |
| Switching | BREAK-BEFORE-MAKE |
| Normal Position | NC |
| Height Seated (Max) | 5.33mm |
| Length | 19.17mm |
| Width | 7.62mm |
| RoHS Status | Non-RoHS Compliant |
HI3-0201-5 Overview
The electrical component comes in 16-DIP (0.300, 7.62mm) packaging, which makes it convenient to ship overseas. High reliability is achieved by using advanced packaging method Tube. Through Hole is where this multiplexer is located. Multiplexers and demultiplexers have a ratio of 1:1. Temperatures around 0°C~70°C TA are extended for operation. Total terminations are 16. A 1 channel electronic part produces high-quality output. In the case of a voltage supply of 15V volts, the electrical part can be powered up and run. An electrical component like this is included in the 16 series. Circuits based on SPST - NC switching are used to construct these analog switch ics. 4 circuits are used in this analogue multiplexer. Multiplexer or Switches is a typical switch device. There are SEPARATE OUTPUT outputs on this analog switch ic.
HI3-0201-5 Features
1 Channels
Switch Circuit: SPST - NC
HI3-0201-5 Applications
There are a lot of Rochester Electronics, LLC HI3-0201-5 Analog Switches & Multiplexers ICs applications.
- Industrial
- SDH/SONET multiplexers
- Avionics and Military Systems
- Communication systems
- Multiplexers
- Fault Tolerant Systems
- PBX interfaces
- ISDN NT1/TA
- Public switching systems
- Battery Powered Instruments
