HI9P0509-5Z
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Package / Case | SOIC N |
| Number of Pins | 16 |
| Packaging | Bulk |
| Published | 1999 |
| JESD-609 Code | e3 |
| Pbfree Code | no |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 3 |
| Number of Terminations | 16 |
| Resistance | 400Ohm |
| Terminal Finish | Matte Tin (Sn) - annealed |
| Max Operating Temperature | 75°C |
| Min Operating Temperature | 0°C |
| Technology | CMOS |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 240 |
| Number of Functions | 1 |
| Supply Voltage | 15V |
| Pin Count | 16 |
| Number of Outputs | 2 |
| Temperature Grade | COMMERCIAL EXTENDED |
| Number of Channels | 1 |
| Max Supply Voltage | 25V |
| Min Supply Voltage | 20V |
| Operating Supply Current | 1.5mA |
| Nominal Supply Current | 2.4mA |
| Power Dissipation | 51mW |
| Throw Configuration | 4PST |
| Turn On Delay Time | 250 ns |
| Logic Function | Multiplexer |
| Number of Inputs | 8 |
| Supply Type | Dual |
| Neg Supply Voltage-Nom (Vsup) | -15V |
| Turn-Off Delay Time | 250 ns |
| Max Dual Supply Voltage | 22V |
| Min Dual Supply Voltage | 10V |
| Off-state Isolation-Nom | 68 dB |
| On-state Resistance Match-Nom | 9Ohm |
| Switching | BREAK-BEFORE-MAKE |
| Length | 9.9mm |
| Width | 3.9mm |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
HI9P0509-5Z Overview
Presented in SOIC N, this electrical component is convenient for overseas shipping. The advanced packaging method Bulk provides high reliability. The total number of terminations is 16. By its 1 channels, the electronic component provides high-quality output. When a voltage supply of 15V is used, the electronic component should be turned on and run. The electronic part body is injected with 16 pins. Analog switches have 400Ohm internal resistance. Please refer to the datasheets for 16 pins functions. In a normalsituation, users should not supply the switches with voltage higher than 25V. The digital multiplexer has a low cost Dual supply. It is recommended to use 20V as the lowest voltage for the electrical part. 1.5mA current would be enough for this multiplexer to operate. For this switch device, it is feasible to have two supplies. However, the voltage should not exceed 22V. In the case of dual power supplies, you should connect at least 10V. The 8 inputs need to be operated in order to work. An environment with a temperature greater than 75°C should not be used to operate the digital switches. An output of 2 is provided by the digital multiplexer.
HI9P0509-5Z Features
1 Channels
1.5mA Supply Current
HI9P0509-5Z Applications
There are a lot of Intersil (Renesas Electronics America) HI9P0509-5Z Analog Switches & Multiplexers ICs applications.
- SONET/SDH ADM
- Power routing
- Private Branch Exchange (PBX)
- Battery Powered Systems
- DSUs
- Relay Replacement
- Cell phones
- Access Concentrators
- Optical Applications
- Channelized and Unchannelized DS3 applications
