HIP1011CB
| Parameters | |
|---|---|
| Mounting Type | Surface Mount |
| Package / Case | 16-SOIC (0.154, 3.90mm Width) |
| Surface Mount | YES |
| Operating Temperature | 0°C~70°C |
| Packaging | Tube |
| JESD-609 Code | e0 |
| Feature | Latched Fault, UVLO |
| Pbfree Code | no |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 16 |
| Type | Hot Plug Controller |
| Terminal Finish | TIN LEAD |
| Applications | CompactPCI™ |
| Voltage - Supply | 10.8V~13.2V |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 240 |
| Number of Functions | 1 |
| Supply Voltage | 12V |
| Terminal Pitch | 1.27mm |
| Reach Compliance Code | unknown |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Pin Count | 16 |
| JESD-30 Code | R-PDSO-G16 |
| Qualification Status | COMMERCIAL |
| Supply Voltage-Max (Vsup) | 13.2V |
| Supply Voltage-Min (Vsup) | 10.8V |
| Number of Channels | 4 |
| Current - Output (Max) | 100mA 500mA |
| Adjustable Threshold | YES |
| Current - Supply | 5mA |
| Internal Switch(s) | Both |
| Programmable Features | Circuit Breaker, Fault Timeout, Slew Rate |
| Feature Pins | FLTN, OCSET, PWRON |
| Height Seated (Max) | 1.75mm |
| Length | 9.9mm |
| Width | 3.9mm |
| RoHS Status | Non-RoHS Compliant |
HIP1011CB Overview
It's included in the 16-SOIC (0.154, 3.90mm Width) package.In the current state, 4 channels are accessible.The package resembles a Tube.There are a total of 16 terminations on it.Device position DUAL is its terminal position.In total, there are 16 pins on it.High efficiency can be achieved by using 12V as supply voltage.The way it's set up is the way Surface Mount wants it.Electrical components classified as Hot Plug Controller are referred to as Hot Plug Controller components.If you want reliable performance, you should set the temperature to 0°C~70°C.The device has CompactPCI? applicationsIn Latched Fault, UVLO, it is featured.In the case of a 10.8V~13.2VV power source, it should work just fine.There are Circuit Breaker, Fault Timeout, Slew Rate programmable features on this device.This is the current supply of 5mA.The supply voltage (Vsup) should be kept above 10.8V for normal operation.Set Vsup to 13.2V for maximum supply voltage.Device output is 100mA 500mAV at its maximum.
HIP1011CB Features
The terminal position of 16
Features of Latched Fault, UVLO
Programmable features of Circuit Breaker, Fault Timeout, Slew Rate
HIP1011CB Applications
There are a lot of Rochester Electronics, LLC HIP1011CB hot swap controllers applications.
- Firewire
- Continuous monitoring of device temperature
- Industrial
- Undervoltage protection
- Limitting the inrush current
- Automatic restart after load failure
- Other forms of communications infrastructure
- Network switches
- Disconnect faulty loads before supply voltage drops
- Network switch
