HIP2101IRZ
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Package / Case | VQFN |
| Number of Pins | 16 |
| Published | 2001 |
| JESD-609 Code | e3 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 3 |
| Number of Terminations | 16 |
| ECCN Code | EAR99 |
| Terminal Finish | Matte Tin (Sn) - annealed |
| Max Operating Temperature | 150°C |
| Min Operating Temperature | -40°C |
| Subcategory | MOSFET Drivers |
| Technology | CMOS |
| Terminal Position | QUAD |
| Terminal Form | NO LEAD |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 12V |
| Terminal Pitch | 0.8mm |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Qualification Status | Not Qualified |
| Max Output Current | 2A |
| Temperature Grade | AUTOMOTIVE |
| Max Supply Voltage | 114V |
| Min Supply Voltage | 9V |
| Power Dissipation-Max | 3.3W |
| Nominal Supply Current | 3mA |
| Max Supply Current | 3mA |
| Current - Output | 2A |
| Turn On Delay Time | 13 ns |
| Rise Time | 600ns |
| Fall Time (Typ) | 600 ns |
| Turn-Off Delay Time | 13 ns |
| Interface IC Type | HALF BRIDGE BASED MOSFET DRIVER |
| Number of Drivers | 2 |
| Turn On Time | 0.056 µs |
| Output Peak Current Limit-Nom | 2A |
| High Side Driver | YES |
| Turn Off Time | 0.056 µs |
| Height Seated (Max) | 1mm |
| Length | 5mm |
| Width | 5mm |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
HIP2101IRZ Overview
The VQFN package provides greater flexibility.Configuration is based on 2 drivers.16 terminations constitute its foundation.You mount it with Surface Mount.At the time of design, it is configured with 16 pins.A voltage of 12V is required for its operation.Mosfet driver employs an interface chip called HALF BRIDGE BASED MOSFET DRIVER as Mosfet drivers interface chip.Mosfet driver is possible for the output current to be as low as 2A.This subcategory of MOSFET Drivers has a number of useful electronic components.150°C is the maximum acceptable operating temperature.There is a minimum operating temperature of -40°C.Mosfet gate drivers is recommended that you keep the supply current at 3mA in order to achieve greater stabilMosfet gate driversy.When the supply voltage is 114V, it is at its maximum operation.In order for the device to operate, a supply voltage of 9V must be applied.Mosfet gate drivers outputs a current of 2A.
HIP2101IRZ Features
2 drivers
16 pins
HIP2101IRZ Applications
There are a lot of Intersil (Renesas Electronics America) HIP2101IRZ gate drivers applications.
- Isolated Supplies for controller area network (CAN),
- Active Clamp Flyback or Forward and Synchronous Rectifier
- A/D drivers
- Isolated Supplies for Motor Control
- High power buffers
- Motor Controls
- Power factor correction (PFC) circuits
- Solar power supplies
- General Purpose 3-Phase Inverter
- Telecom switch mode power supplies
