IDT7201LA12SO
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Package / Case | SOIC |
| Published | 2009 |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Moisture Sensitivity Level (MSL) | 3 |
| Number of Terminations | 28 |
| ECCN Code | EAR99 |
| Terminal Finish | Tin/Lead (Sn85Pb15) |
| Max Operating Temperature | 70°C |
| Min Operating Temperature | 0°C |
| Additional Feature | RETRANSMIT |
| HTS Code | 8542.32.00.71 |
| Subcategory | FIFOs |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 225 |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Terminal Pitch | 1.27mm |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Pin Count | 28 |
| JESD-30 Code | R-PDSO-G28 |
| Supply Voltage-Max (Vsup) | 5.5V |
| Power Supplies | 5V |
| Temperature Grade | COMMERCIAL |
| Supply Voltage-Min (Vsup) | 4.5V |
| Max Supply Current | 80mA |
| Clock Frequency | 50MHz |
| Access Time | 12 ns |
| Organization | 512X9 |
| Output Characteristics | 3-STATE |
| Memory Width | 9 |
| Standby Current-Max | 0.0005A |
| Memory Density | 4608 bit |
| Parallel/Serial | PARALLEL |
| Memory IC Type | OTHER FIFO |
| Bus Directional | Unidirectional |
| Retransmit Capability | Yes |
| FWFT Support | No |
| Output Enable | NO |
| Cycle Time | 20 ns |
| Height Seated (Max) | 3.048mm |
| Length | 18.3642mm |
| Width | 8.763mm |
| RoHS Status | Non-RoHS Compliant |
IDT7201LA12SO Overview
FIFO memory chip is included in the SOIC package.A Surface Mount mounting method is recommended.High efficiency is possible with a supply voltage of 5V .FIFO means contains a total of 28 terminations.In order for FIFO design to operate, FIFO design requires a maximum current of 80mA .It is designed to run at a minimum temperature of 0°C degrees Celsius to ensure reliability.An operating temperature of 70°C °C is necessary for stable operation.The gadget is self-contained and can be found in FIFOs .It has a OTHER FIFO memory type IC.There are a total of 28 pins on this board.The component normally owns 5V power supplies.It is also possible to generate RETRANSMIT using this FIFO memory.The FIFO memory IC's maximum supply voltage is set to 5.5V .The supply voltage (Vsup) should remain above 4.5V to ensure normal operation.In this FIFO memory IC, the clock runs at frequency 50MHz .
IDT7201LA12SO Features
FIFOs category
Clock frequency of 50MHz
IDT7201LA12SO Applications
There are a lot of Integrated Device Technology (IDT) IDT7201LA12SO FIFOs Memory applications.
- Cameras
- Disk Controllers
- Fabrication Site
- Test site
- Multimedia
- Cardiac Monitoring Device
- Temporary storage elements
- Computer networks
- Thermal Management for DDR3 Memory Modules
- Programmable Logic Controller
