IDT7204L12SO
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Package / Case | SOIC |
| Published | 2009 |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Moisture Sensitivity Level (MSL) | 3 |
| Number of Terminations | 28 |
| ECCN Code | EAR99 |
| Terminal Finish | Tin/Lead (Sn85Pb15) |
| Max Operating Temperature | 70°C |
| Min Operating Temperature | 0°C |
| Additional Feature | RETRANSMIT |
| HTS Code | 8542.32.00.71 |
| Subcategory | FIFOs |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 225 |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Terminal Pitch | 1.27mm |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Pin Count | 28 |
| JESD-30 Code | R-PDSO-G28 |
| Qualification Status | Not Qualified |
| Supply Voltage-Max (Vsup) | 5.5V |
| Power Supplies | 5V |
| Temperature Grade | COMMERCIAL |
| Supply Voltage-Min (Vsup) | 4.5V |
| Operating Mode | ASYNCHRONOUS |
| Clock Frequency | 50MHz |
| Supply Current-Max | 0.12mA |
| Access Time | 12 ns |
| Organization | 4KX9 |
| Output Characteristics | 3-STATE |
| Memory Width | 9 |
| Standby Current-Max | 0.002A |
| Memory Density | 36864 bit |
| Parallel/Serial | PARALLEL |
| Memory IC Type | OTHER FIFO |
| Output Enable | NO |
| Cycle Time | 20 ns |
| Height Seated (Max) | 3.048mm |
| Length | 18.3642mm |
| Width | 8.763mm |
| RoHS Status | RoHS Compliant |
IDT7204L12SO Overview
The SOIC package contains FIFO memory chip.It is pointing in the direction of Surface Mount .A supply voltage of 5V is capable of producing high efficiency.FIFO means contains 28 terminations.The FIFO products must be run at a minimum temperature of 0°C degrees Celsius to ensure reliability.Keeping the operating temperature at 70°C °C allows the FIFO products to operate continuously.This gadget is self-contained in?FIFOs .The IC of the part is of the type OTHER FIFO .As a result, it contains a total of 28 pins.There are normally 5V power supplies attached to the component.Additionally, this FIFO memory can be used to generate RETRANSMIT .In this case, the FIFO memory IC's maximum supply voltage is set to 5.5V .To ensure normal operation, make sure the supply voltage (Vsup) is above 4.5V .The FIFO memory IC runs at a frequency of 50MHz .
IDT7204L12SO Features
FIFOs category
Clock frequency of 50MHz
IDT7204L12SO Applications
There are a lot of Integrated Device Technology (IDT) IDT7204L12SO FIFOs Memory applications.
- Switches
- General Data Collection Applications at Low-Temperatures
- Network bridges
- Signal processing
- Network switching/routing
- Data communications
- Industrial Systems
- Controlled baseline
- Laser Receiver System
- TVs
