IDT74FCT2374ATQG8
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Package / Case | SSOP |
| Number of Pins | 20 |
| Packaging | Tape and Reel |
| Published | 2009 |
| JESD-609 Code | e3 |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 20 |
| Terminal Finish | Matte Tin (Sn) - annealed |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Subcategory | FF/Latches |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | NOT SPECIFIED |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Terminal Pitch | 0.635mm |
| Reach Compliance Code | unknown |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| Pin Count | 20 |
| Qualification Status | Not Qualified |
| Operating Supply Voltage | 5V |
| Number of Elements | 1 |
| Polarity | Non-Inverting |
| Power Supplies | 5V |
| Temperature Grade | INDUSTRIAL |
| Max Supply Voltage | 5.25V |
| Min Supply Voltage | 4.75V |
| Load Capacitance | 50pF |
| Number of Ports | 2 |
| Number of Bits | 8 |
| Propagation Delay | 6.5 ns |
| Turn On Delay Time | 2 ns |
| Family | FCT |
| Output Characteristics | 3-STATE WITH SERIES RESISTOR |
| Logic IC Type | BUS DRIVER |
| High Level Output Current | 12mA |
| Low Level Output Current | 15mA |
| Clock Edge Trigger Type | Positive Edge |
| Width | 3.937mm |
| RoHS Status | RoHS Compliant |
IDT74FCT2374ATQG8 Overview
SSOPis the packaging method. There is an embedded version in the package Tape and Reel. In total, it contains 1 elements. The number of terminations is 20. It is powered from a supply voltage of 5V. This D flip flop belongs to the family of FCT. In this case, the electronic component is mounted in the way of Surface Mount. The 20pins are designed into the board. A Positive Edgeclock edge trigger is used in this device. This device has the base part number FF/Latches. The design is based on 8bits. The system runs on a power supply of 5V watts. The flip flop has 2ports embedded within it. The supply voltage should be maintained at 5V for high efficiency. It is set to 12mAfor the high level output current. The low level output current is set to 15mA. Temperatures below 85°Care ideal for operating. Operating temperatures should be above -40°C. The minimal supply voltage is 4.75V. It supports the maximal supply voltage of 5.25V. It uses BUS DRIVERas its logic IC. It is equipped with 1 functions . The D latch is equipped with 20 pins.
IDT74FCT2374ATQG8 Features
Tape and Reel package
20 pins
8 Bits
5V power supplies
1 Functions
20 pin count
IDT74FCT2374ATQG8 Applications
There are a lot of Integrated Device Technology (IDT) IDT74FCT2374ATQG8 Flip Flops applications.
- Event Detectors
- Functionally equivalent to the MC10/100EL29
- Dynamic threshold performance
- Consumer
- Synchronous counter
- 2 – Bit synchronous counter
- Memory
- Registers
- Power down protection
- Single Down Count-Control Line
