IDT74FCT374ATSO
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Package / Case | SOIC |
| Number of Pins | 20 |
| Published | 2009 |
| JESD-609 Code | e0 |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 20 |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Subcategory | FF/Latches |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 225 |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Reach Compliance Code | not_compliant |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Pin Count | 20 |
| Qualification Status | Not Qualified |
| Operating Supply Voltage | 5V |
| Number of Elements | 1 |
| Polarity | Non-Inverting |
| Power Supplies | 5V |
| Temperature Grade | INDUSTRIAL |
| Max Supply Voltage | 5.25V |
| Min Supply Voltage | 4.75V |
| Load Capacitance | 50pF |
| Number of Ports | 2 |
| Number of Bits | 8 |
| Propagation Delay | 6.5 ns |
| Turn On Delay Time | 2 ns |
| Family | FCT |
| Output Characteristics | 3-STATE |
| Logic IC Type | BUS DRIVER |
| High Level Output Current | 48mA |
| Low Level Output Current | 15mA |
| Clock Edge Trigger Type | Positive Edge |
| Width | 7.5mm |
| RoHS Status | Non-RoHS Compliant |
IDT74FCT374ATSO Overview
The package is in the form of SOIC. In total, there are 1 elements. There are 20 terminations, which are the practice of ending a transmission line with a device that matches the characteristic impedance of the line. It is powered from a supply voltage of 5V. An electronic device belonging to the family FCTcan be found here. There is an electronic component mounted in the way of Surface Mount. This board has 20 pins. The clock edge trigger type for this device is Positive Edge. This RS flip flops is a part number FF/Latches. An electronic part designed with 8bits is used in this application. The power supply is 5V. The flip flop contains 2ports. The supply voltage should be maintained at 5V for high efficiency. In this case, the high level output current is set to 48mA. There is 15mA output current at the low level. A temperature below 85°Cshould be used for operation. Ideally, the operating temperature should be greater than -40°C. It is powered by 4.75V as its minimum supply voltage. 5.25Vis the maximum supply voltage supported by it. It uses BUS DRIVERas its logic IC. Currently, it is equipped with 1 functions . The JK flip flop has a pin count of 20.
IDT74FCT374ATSO Features
20 pins
8 Bits
5V power supplies
1 Functions
20 pin count
IDT74FCT374ATSO Applications
There are a lot of Integrated Device Technology (IDT) IDT74FCT374ATSO Flip Flops applications.
- Storage Registers
- Common Clocks
- ESD performance
- Balanced 24 mA output drivers
- Memory
- ESCC
- Matched Rise and Fall
- Automotive
- Shift Registers
- Functionally equivalent to the MC10/100EL29
