IDT74FCT374CTPYG
| Parameters | |
|---|---|
| Output Characteristics | 3-STATE |
| Logic IC Type | BUS DRIVER |
| High Level Output Current | 48mA |
| Low Level Output Current | 15mA |
| Clock Edge Trigger Type | Positive Edge |
| Length | 7.2mm |
| Width | 5.3mm |
| RoHS Status | RoHS Compliant |
| Mount | Surface Mount |
| Package / Case | SSOP |
| Number of Pins | 20 |
| Packaging | Rail/Tube |
| Published | 2009 |
| JESD-609 Code | e3 |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 20 |
| Terminal Finish | MATTE TIN |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Terminal Pitch | 0.65mm |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Pin Count | 20 |
| Qualification Status | Not Qualified |
| Operating Supply Voltage | 5V |
| Number of Elements | 1 |
| Polarity | Non-Inverting |
| Temperature Grade | INDUSTRIAL |
| Max Supply Voltage | 5.25V |
| Min Supply Voltage | 4.75V |
| Number of Ports | 2 |
| Number of Bits | 8 |
| Propagation Delay | 5.5 ns |
| Turn On Delay Time | 2 ns |
| Family | FCT |
IDT74FCT374CTPYG Overview
The flip flop is packaged in a case of SSOP. A package named Rail/Tubeincludes it. The list contains 1 elements. There are 20 terminations,Power is supplied from a voltage of 5V volts. It is a member of the FCTfamily of D flip flop. In this case, the electronic component is mounted in the way of Surface Mount. As you can see from the design, it has pins with 20. A Positive Edgeclock edge trigger is used in this device. There are 8bits in this flip flop. The D flip flop is embedded with 2ports. If high efficiency is desired, the supply voltage should be kept at 5V. A 48mAis set for the high level output current. There is 15mA output current at the low level. A temperature below 85°Cshould be used for operation. It should be higher than -40°Cwhen the system is operating. A minimum supply voltage of 4.75V is required for these RS flip flops to operate. 5.25Vis the maximum supply voltage it supports. It adopts a logic IC of type BUS DRIVER. A total of 1 functions are provided by this T flip flop. 20pins are available on this JK flip flop.
IDT74FCT374CTPYG Features
Rail/Tube package
20 pins
8 Bits
1 Functions
20 pin count
IDT74FCT374CTPYG Applications
There are a lot of Integrated Device Technology (IDT) IDT74FCT374CTPYG Flip Flops applications.
- Memory
- Frequency Divider circuits
- Differential Individual
- Data transfer
- Automotive
- Power down protection
- Balanced Propagation Delays
- ESCC
- Data Synchronizers
- Clock pulse
