IH5142CWE
| Parameters | |
|---|---|
| Charge Injection | 15pC |
| Channel-to-Channel Matching (ΔRon) | 5 Ω |
| Switching | BREAK-BEFORE-MAKE |
| Switch-on Time-Max | 200ns |
| Voltage - Supply, Dual (V±) | ±4.5V~18V |
| Height Seated (Max) | 2.65mm |
| Width | 7.5mm |
| Radiation Hardening | No |
| RoHS Status | Non-RoHS Compliant |
| Lead Free | Contains Lead |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 16-SOIC (0.295, 7.50mm Width) |
| Operating Temperature | 0°C~70°C TA |
| Packaging | Tube |
| Published | 1996 |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 16 |
| Resistance | 100Ohm |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 240 |
| Number of Functions | 1 |
| Supply Voltage | 15V |
| Time@Peak Reflow Temperature-Max (s) | 20 |
| Base Part Number | IH5142 |
| Pin Count | 16 |
| Number of Channels | 1 |
| Number of Circuits | 1 |
| Number of Bits | 4 |
| Supply Type | Dual |
| Neg Supply Voltage-Nom (Vsup) | -15V |
| Max Dual Supply Voltage | 18V |
| On-State Resistance (Max) | 100Ohm |
| Min Dual Supply Voltage | 4.5V |
| Multiplexer/Demultiplexer Circuit | 2:1 |
| Off-state Isolation-Nom | 50 dB |
| Current - Leakage (IS(off)) (Max) | 100nA |
| On-state Resistance Match-Nom | 5Ohm |
| Switch Circuit | SPDT |
| Switch Time (Ton, Toff) (Max) | 300ns, 150ns |
IH5142CWE Overview
Packed in 16-SOIC (0.295, 7.50mm Width), the electronic component is convenient for shipping overseas. High reliability is achieved by using advanced packaging method Tube. There is an analog multiplexer mounted in position Surface Mount. Multiplexer and demultiplexer circuits have a number 2:1. An extended operating temperature of 0°C~70°C TA degrees Celsius. In total, 16 terminations have occurred. This electronic part offers high-quality output due to its 1 channels. In the case of a voltage supply of 15V volts, the electrical part can be powered up and run. A total of 16 pins are injected into the body of the electronic part. These analog multiplexers are built based on SPDT switching circuits. The circuits in this analogue multiplexer number 1. If you are looking for variants of the digital switch, trying search with IH5142. In this multiplexer, the internal resistance is 100Ohm. This switch device is a typical Multiplexer or Switches. A cost-effective Dual supply type analogue multiplexer. For this switch, a dual supply voltage is feasible, but it must not exceed 18VFor dual power supplies, a voltage of at least 4.5V should be attached. 4-bit operation is possible.
IH5142CWE Features
1 Channels
Switch Circuit: SPDT
4-Bit
IH5142CWE Applications
There are a lot of Maxim Integrated IH5142CWE Analog Switches & Multiplexers ICs applications.
- Communications systems
- Avionics
- High-Voltage
- Microprocessor controlled systems
- Cellular phones
- Video signal routing
- Cable Modem
- PCMCIA cards
- Switching Systems
- CSU
