INA106U/2K5G4
| Parameters | |
|---|---|
| Package / Case | D |
| Surface Mount | YES |
| Number of Pins | 8 |
| Weight | 75.891673mg |
| Packaging | Tape and Reel |
| JESD-609 Code | e4 |
| Pbfree Code | yes |
| Moisture Sensitivity Level (MSL) | 3 |
| Number of Terminations | 8 |
| ECCN Code | EAR99 |
| Resistance | 110kOhm |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Subcategory | Operational Amplifier |
| Technology | BIPOLAR |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 15V |
| Pin Count | 8 |
| Number of Elements | 1 |
| Temperature Grade | COMMERCIAL |
| Max Supply Voltage | 36V |
| Min Supply Voltage | 10V |
| Nominal Supply Current | 1.5mA |
| Quiescent Current | 1.5mA |
| Slew Rate | 3 V/μs |
| Amplifier Type | OPERATIONAL AMPLIFIER |
| Common Mode Rejection Ratio | 86 dB |
| Input Offset Voltage (Vos) | 200μV |
| Bandwidth | 5MHz |
| Neg Supply Voltage-Nom (Vsup) | -15V |
| Voltage Gain | 20dB |
| Max Dual Supply Voltage | 18V |
| Min Dual Supply Voltage | 5V |
| Dual Supply Voltage | 15V |
| Length | 4.9mm |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
| Lead Free | Contains Lead |
INA106U/2K5G4 Overview
There is a D case package that contains the instrumentation amplifiers. This is a OPERATIONAL AMPLIFIER type op amp. A Tape and Reel case is used for delivering the op amp. There is a growing number of terminations approaching the number of 8. The total number of pins on linear amplifier is 8. It would be helpful if you could remember that this op amp ic should be powered by an 15V battery. I would like to specify that this buffer amplifier belongs to the Operational Amplifier-type of devices. Linear amplifier includes 8 pins. In terms of input offset voltage, operational amplifier rates 200μV. Maintain 20dB as the voltage gain. It is recommended that the temperature of this op amp ic should not fall below -40°C degrees Fahrenheit at any time. At temperatures greater than 85°C, op amp should not be used. A voltage rating of 1 is indicated for the op amp's operating supply voltage. I would like to point out that this electrical component is capable of working from a voltage below 36V as far as the power supply is concerned. A high supply voltage of more than 10V is recommended for the instrumentation amplifier's supply voltage. The dual supply voltage of 18V should be used for the conduct of this electronic component. The quiescent current is 1.5mA. During testing, the buffer amplifier resistance should remain within a range of 110kOhm.
INA106U/2K5G4 Features
8 Pins
supply voltage of 15V
20dB voltage gain
Resistance of 110kOhm
INA106U/2K5G4 Applications
There are a lot of Texas Instruments INA106U/2K5G4 Instrumentational OP Amps applications.
- Medical imaging
- Portable media players
- Test and measurement instruments
- Thermocouples
- Communication device
- single/dual op amp sum and difference circuits
- Band-pass filter
- Exponential operation circuits
- Information processing
- Computer workstations
