INA210AIDCKR
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Lifecycle Status | ACTIVE (Last Updated: 5 days ago) |
| Contact Plating | Gold |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 6-TSSOP, SC-88, SOT-363 |
| Number of Pins | 6 |
| Weight | 2.494758mg |
| Operating Temperature | -40°C~125°C |
| Packaging | Tape & Reel (TR) |
| JESD-609 Code | e4 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 2 (1 Year) |
| Number of Terminations | 6 |
| ECCN Code | EAR99 |
| Subcategory | Operational Amplifier |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Base Part Number | INA210 |
| Pin Count | 6 |
| Operating Supply Voltage | 3V |
| Number of Elements | 1 |
| Operating Supply Current | 65μA |
| Nominal Supply Current | 115μA |
| Accuracy | 1 % |
| Slew Rate | 0.4V/μs |
| Amplifier Type | Current Sense |
| Common Mode Rejection Ratio | 105 dB |
| Current - Input Bias | 28μA |
| Voltage - Supply, Single/Dual (±) | 2.7V~26V |
| Input Offset Voltage (Vos) | 35μV |
| Bandwidth | 14 kHz |
| Voltage Gain | 46.02dB |
| Power Supply Rejection Ratio (PSRR) | 140dB |
| Voltage - Input Offset | 0.55μV |
| Height | 1.1mm |
| Length | 2mm |
| Width | 1.25mm |
| Thickness | 900μm |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
| Lead Free | Lead Free |
INA210AIDCKR Overview
Op amp is packaged in 6-TSSOP, SC-88, SOT-363 case. Op amps are Current Sense types of amplifier on the chip. As far as the packaging is concerned, buffer op amp is delivered in a Tape & Reel (TR) case. In recent months, the number of terminations has approached 6. In total, there are 6 pins on this op amp ic. A type of Operational Amplifier buffer op amp is what this device is specifically, to be more precise. A total of 6 pins are present on the instrumentation amplifier. Regarding input offset voltage, buffer amplifier rates 35μV voltage. For this electrical component, the recommended mounting type is Surface Mount, which is the most common. In terms of operating temperature, this instrumentation amplifier performs well at a temperature of about -40°C~125°C . As long as the supply current of the chip does not exceed 65μA, this op amp ic can operate. You should keep the voltage gain at 46.02dB for the time being. The linear amplifier consists of 1 different elements in total. The operating supply voltage of the buffer op amp is rated at 3V.
INA210AIDCKR Features
6 Pins
46.02dB voltage gain
INA210AIDCKR Applications
There are a lot of Texas Instruments INA210AIDCKR Instrumentational OP Amps applications.
- Power control
- Power generator
- Inverse/same-phase proportional circuit
- Automotive sensors
- Exponential operation circuits
- Large motor controllers
- Measurements of Wheatstone bridge
- Weak signal detection
- Proportional operation circuits
- ECG equipment
