IP82C54-10
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Contact Plating | Lead, Tin |
| Mount | Through Hole |
| Package / Case | PDIP |
| Number of Pins | 24 |
| Packaging | Bulk |
| Published | 1996 |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Part Status | Active |
| Number of Terminations | 24 |
| ECCN Code | EAR99 |
| Terminal Finish | Tin/Lead (Sn/Pb) |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Additional Feature | 6 PROGRAMMABLE MODES |
| Technology | CMOS |
| Terminal Position | DUAL |
| Supply Voltage | 5V |
| Frequency | 10MHz |
| Pin Count | 24 |
| Operating Supply Voltage | 5V |
| Temperature Grade | INDUSTRIAL |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 4.5V |
| Operating Supply Current | 10mA |
| uPs/uCs/Peripheral ICs Type | TIMER, PROGRAMMABLE |
| Number of Bits | 16 |
| Propagation Delay | 100 ns |
| Number of Timers/Counters | 1 |
| High Level Output Current | -2.5mA |
| External Data Bus Width | 8 |
| Low Level Output Current | 2.5mA |
| Bus Compatibility | 80C86; 80C88; 80C286 |
| Information Access Method | PARALLEL, DIRECT ADDRESS |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
| Lead Free | Contains Lead |
IP82C54-10 Overview
In the packaging, the clock timer is enclosed with the PDIP code on the back. In this case, the programmable timer's frequency is set to 10MHz.It is used to pack in Bulk case. To mount this digital timer with Through Hole. The operating supply voltage is rated at 10mA voltage. The minimum operating temperature of the chip must not be lower than -40°C. It's best to use the timer clock when the temperature is below 85°C. The timer clock contains 24 pins. The digital timer's operating supply voltage is rated 5V voltage. The supply voltage of the programmable timer can rate 5V. You can read the timer clock's additional feature in the follwing: 6 PROGRAMMABLE MODES. The sum of the IC chip pins is 24 . The number of the chip's terminations sums up to 24. The minimum supply voltage of the chip must not be lower than 4.5V. The supply voltage of this chip should not exceed 5.5V. The number of Timers/Counters on the device is 1.
IP82C54-10 Features
Operate frequency at 10MHz
Package / Case: Bulk
Max Operating temperature at -40°C
Additional Feature: 6 PROGRAMMABLE MODES
1 Timers/Counters
IP82C54-10 Applications
There are a lot of Intersil (Renesas Electronics America) IP82C54-10 Programmable Timers & Oscillators applications.
- Long Time One Shot
- Internet of Things (IoT)
- Car Door Handle circuit
- Delay circuits
- Clutch Actuator circuit
- Remote Sensors
- High Vibration, High Acceleration Environments
- Building Automation
- Intruder Detection
- Sensor Node
