banner_page

IS82C54-1096

5V Programmable Timers 28 Pins 10MHz 5V PLCC


  • Manufacturer: Intersil (Renesas Electronics America)
  • Nocochips NO: 391-IS82C54-1096
  • Package: PLCC
  • Datasheet: PDF
  • Stock: 804
  • Description: 5V Programmable Timers 28 Pins 10MHz 5V PLCC (Kg)

Details

Tags

Parameters
Factory Lead Time 1 Week
Mount Surface Mount
Package / Case PLCC
Number of Pins 28
Published 1996
JESD-609 Code e0
Pbfree Code no
Part Status Active
Moisture Sensitivity Level (MSL) 1
Number of Terminations 28
ECCN Code EAR99
Terminal Finish Tin/Lead (Sn/Pb)
Max Operating Temperature 85°C
Min Operating Temperature -40°C
Technology CMOS
Terminal Position QUAD
Terminal Form J BEND
Peak Reflow Temperature (Cel) 225
Supply Voltage 5V
Frequency 10MHz
Pin Count 28
Operating Supply Voltage 5V
Temperature Grade INDUSTRIAL
Max Supply Voltage 5.5V
Min Supply Voltage 4.5V
Operating Supply Current 10mA
uPs/uCs/Peripheral ICs Type TIMER, PROGRAMMABLE
Number of Bits 16
Propagation Delay 100 ns
Number of Timers/Counters 1
High Level Output Current -2.5mA
External Data Bus Width 8
Low Level Output Current 2.5mA
Information Access Method PARALLEL, DIRECT ADDRESS
Height Seated (Max) 4.57mm
Radiation Hardening No
RoHS Status RoHS Compliant
Lead Free Contains Lead

IS82C54-1096 Overview


The timer clock is suitable for PLCC package. A frequency of 10MHz is set for the programmable timer.To mount this digital timer with Surface Mount. The operating supply voltage is rated at 10mA voltage. The minimum operating temperature of the chip must not be lower than -40°C. It's best to use the timer clock when the temperature is below 85°C. The timer clock contains 28 pins. The digital timer's operating supply voltage is rated 5V voltage. The supply voltage of the programmable timer can rate 5V. The sum of the IC chip pins is 28 . The number of the chip's terminations sums up to 28. The minimum supply voltage of the chip must not be lower than 4.5V. The supply voltage of this chip should not exceed 5.5V. The number of Timers/Counters on the device is 1.

IS82C54-1096 Features


Operate frequency at 10MHz
Max Operating temperature at -40°C
1 Timers/Counters

IS82C54-1096 Applications


There are a lot of Intersil (Renesas Electronics America) IS82C54-1096 Programmable Timers & Oscillators applications.

  • Clutch Actuator circuit
  • Sensor Node
  • Precision timing
  • Delay circuits
  • Low-Power Wireless
  • Power-Gating Applications
  • Always On Systems
  • Internet of Things (IoT)
  • Intruder Detection
  • Power-On Reset Timer

Write a review

Note: HTML is not translated!
    Bad           Good