ISL43110IH-T
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Package / Case | SOT-23-5 |
| Number of Pins | 5 |
| Packaging | Cut Tape |
| Published | 2001 |
| JESD-609 Code | e0 |
| Part Status | Discontinued |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 5 |
| Resistance | 10Ohm |
| Terminal Finish | Tin/Lead (Sn/Pb) |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 240 |
| Number of Functions | 1 |
| Supply Voltage | 3.3V |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| Pin Count | 5 |
| Qualification Status | Not Qualified |
| Temperature Grade | INDUSTRIAL |
| Supply Voltage-Min (Vsup) | 2.4V |
| Number of Channels | 1 |
| Operating Supply Current | 1μA |
| Number of Bits | 1 |
| Throw Configuration | SPST |
| Supply Type | Single |
| Switching | BREAK-BEFORE-MAKE |
| Switch-off Time-Max | 60ns |
| Normal Position | NO |
| Length | 2.9mm |
| RoHS Status | RoHS Compliant |
| Lead Free | Contains Lead |
ISL43110IH-T Overview
Shipping overseas is convenient due to the electrical component's packing in SOT-23-5. A high level of reliability can be achieved through the use of an advanced packaging method Cut Tape. Totally, there are 5 terminations. By its 1 channels, the electronic component provides high-quality output. A 3.3V voltage supply should turn on and run the electronic component. This electronic part can be found in the 5 series. A 10Ohm internal resistance characterizes this multiplexer. To find out what the 5 pins do, please refer to the datasheets. Theswitch device is a typical Multiplexer or Switches. Single supply type digital switch with a low cost. It would be sufficient to run this analogue multiplexer with 1μA current. The switches should not operate in an environment where the temperature is higher than 85°C. 1-bits are supported. Providing power to the analogue multiplexer requires a voltage of 2.4VV.
ISL43110IH-T Features
1 Channels
1μA Supply Current
1-Bit
ISL43110IH-T Applications
There are a lot of Intersil (Renesas Electronics America) ISL43110IH-T Analog Switches & Multiplexers ICs applications.
- Audio signal routing
- RGB switches
- Fiber In The Loop (FITL)
- DVD-R
- Cellular phones
- Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
- Communication systems
- Digital Cross-Connects
- Low-Voltage
- Private Branch Exchange (PBX)
