ISL43111IB
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Package / Case | SOIC |
| Number of Pins | 8 |
| Packaging | Bulk |
| Published | 2001 |
| JESD-609 Code | e0 |
| Part Status | Discontinued |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 8 |
| Resistance | 10Ohm |
| Terminal Finish | Tin/Lead (Sn/Pb) |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 240 |
| Number of Functions | 1 |
| Supply Voltage | 3.3V |
| Reach Compliance Code | not_compliant |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| Pin Count | 8 |
| Qualification Status | Not Qualified |
| Operating Supply Voltage | 9V |
| Temperature Grade | INDUSTRIAL |
| Number of Channels | 2 |
| Max Supply Voltage | 12V |
| Min Supply Voltage | 2.4V |
| Operating Supply Current | 1μA |
| Max Supply Current | 1μA |
| Number of Bits | 1 |
| Throw Configuration | SPST |
| Turn On Delay Time | 100 ns |
| Supply Type | Single |
| Turn-Off Delay Time | 60 ns |
| Switching | BREAK-BEFORE-MAKE |
| Drain to Source Resistance | 20Ohm |
| Normal Position | NC |
| Length | 4.9mm |
| Width | 3.9mm |
| RoHS Status | Non-RoHS Compliant |
| Lead Free | Contains Lead |
ISL43111IB Overview
The electrical component comes in SOIC packaging, which makes it convenient to ship overseas. This packaging method provides high reliability because it uses advanced packaging techniques. Totally, there are 8 terminations. A high-quality output is provided by the electrical component's 2 channels. An 3.3V voltage supply should allow the electrical part to be turned on and run. There is an electrical component included in the 8 series. An switch multiplexer with 10Ohm internal resistance has a value of 10Ohm. The functions of 8 pins can be found in the datasheets. There is a standard Multiplexer or Switches analogue multiplexer here. An abnormal situation would be for the switch device to be supplied with a voltage greater than 12V. Analog switch ics with Single supply type are cost-effective. The lowest voltage fed to the electronic component should be 2.4V. An operating current of 1μA would be sufficient for this switch device. If you put voltage higher than 1μA on the digital multiplexer, damage may occur. This electrical part is compatible with 9V operating voltages. An environment with a temperature greater than 85°C should not be used to operate the digital switches. Resistivity from Drain to Source is 20Ohm for this electronic part. It is able to conduct in a 1-bit way.
ISL43111IB Features
2 Channels
1μA Supply Current
Drain-to-Source resistance: 20Ohm
1-Bit
ISL43111IB Applications
There are a lot of Intersil (Renesas Electronics America) ISL43111IB Analog Switches & Multiplexers ICs applications.
- ATM
- Cell phones
- Avionics test equipment
- Medical Instrumentation
- Isolation
- Video signal routing
- Audio signal routing
- Audio and video signal routing
- High reliability control systems
- Public switching systems
