ISL43111IBZ
| Parameters | |
|---|---|
| Number of Pins | 8 |
| Packaging | Bulk |
| Published | 2001 |
| JESD-609 Code | e3 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 8 |
| Resistance | 10Ohm |
| Terminal Finish | Matte Tin (Sn) - annealed |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 3.3V |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Temperature Grade | INDUSTRIAL |
| Number of Channels | 2 |
| Max Supply Voltage | 12V |
| Min Supply Voltage | 2.4V |
| Power Dissipation-Max | 5μW |
| Operating Supply Current | 1μA |
| Max Supply Current | 1μA |
| Number of Bits | 1 |
| Throw Configuration | SPST |
| Turn On Delay Time | 80 ns |
| Supply Type | Single |
| Turn-Off Delay Time | 50 ns |
| Switching | BREAK-BEFORE-MAKE |
| Switch-off Time-Max | 60ns |
| Drain to Source Resistance | 20Ohm |
| Normal Position | NC |
| Length | 4.9mm |
| Width | 3.9mm |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Package / Case | SOIC |
ISL43111IBZ Overview
The electrical component comes in SOIC packaging, which makes it convenient to ship overseas. This high-reliability packaging method uses advanced packaging methods Bulk. 8 terminations have been made so far. Due to its 2 channels, the electrical component produces high-quality output. When the electronic component is given a voltage of 3.3V, it should be turned on and run. Analog switches have 10Ohm internal resistance. Datasheets for functions of 8 pins are available. There is a standard Multiplexer or Switches analogue multiplexer here. Users should never supply a voltage higher than 12V to a switch device. A cost-effective Single supply type analogue multiplexer. The lowest voltage fed to the electronic component should be 2.4V. For this multiplexer to operate, 1μA current would be sufficient. If put voltage greater than 1μA on the device, damage may be caused to the analogue multiplexer. A temperature above 85°C is not suitable for operation of the analogue multiplexer. There is 20Ohm resistance between the Drain and Source on this part. 1-bit operation is possible.
ISL43111IBZ Features
2 Channels
1μA Supply Current
Drain-to-Source resistance: 20Ohm
1-Bit
ISL43111IBZ Applications
There are a lot of Intersil (Renesas Electronics America) ISL43111IBZ Analog Switches & Multiplexers ICs applications.
- FTTH
- Avionics test equipment
- Industrial
- Fiber to the Home
- DSLAMs
- High-Voltage
- Voice over IP/DSL – Integrated Access Devices, Smart
- Optical Applications
- RGB switches
- Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
