ISL43111IHZ-T
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Contact Plating | Tin |
| Mount | Surface Mount |
| Package / Case | SOT-23-5 |
| Number of Pins | 5 |
| Packaging | Cut Tape |
| Published | 2001 |
| JESD-609 Code | e3 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 3 |
| Number of Terminations | 5 |
| Resistance | 10Ohm |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 3.3V |
| Time@Peak Reflow Temperature-Max (s) | 40 |
| Pin Count | 5 |
| Polarity | Non-Inverting |
| Temperature Grade | INDUSTRIAL |
| Number of Channels | 1 |
| Max Supply Voltage | 12V |
| Min Supply Voltage | 2.4V |
| Power Dissipation-Max | 5μW |
| Operating Supply Current | 1μA |
| Max Supply Current | 1μA |
| Number of Bits | 1 |
| Throw Configuration | SPST |
| Turn On Delay Time | 80 ns |
| Supply Type | Single |
| Turn-Off Delay Time | 50 ns |
| High Level Output Current | 20mA |
| Switching | BREAK-BEFORE-MAKE |
| Switch-off Time-Max | 60ns |
| Normal Position | NC |
| Length | 2.9mm |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
ISL43111IHZ-T Overview
The electronic part can be shipped overseas conveniently because it is packaged in SOT-23-5. The advanced packaging method Cut Tape provides high reliability. In total, there have been 5 terminations. Due to its 1 channels, the electrical component produces high-quality output. Turning on and running the electrical part should be easy with a 3.3V voltage supply. Into the electrical component body are injected 5 pins. As far as internal resistance is concerned, it has 10Ohm. The functions of 5 pins can be found in the datasheets. Theswitch device is a typical Multiplexer or Switches. It is normally recommended that users do not supply the multiplexer with voltages higher than 12V. The digital multiplexer has a low cost Single supply. It is recommended that the electrical component receives a voltage of 2.4V. For this multiplexer to operate, 1μA current would be sufficient. Put voltage above 1μA on the multiplexer to cause damage. Temperatures above 85°C degrees Celsius should not be operated by the multiplexer. 1-bits are supported.
ISL43111IHZ-T Features
1 Channels
1μA Supply Current
1-Bit
ISL43111IHZ-T Applications
There are a lot of Intersil (Renesas Electronics America) ISL43111IHZ-T Analog Switches & Multiplexers ICs applications.
- Power routing
- Video signal routing
- Fiber In The Loop (FITL)
- PBX interfaces
- Central office
- Channelized and Unchannelized DS3 applications
- Isolation
- Data Acquisition Systems
- 65 V DACs
- Avionics
