ISL43122IH-T
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Package / Case | SOT-23-8 |
| Number of Pins | 8 |
| Packaging | Tape & Reel (TR) |
| Published | 2001 |
| JESD-609 Code | e0 |
| Part Status | Discontinued |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 8 |
| Resistance | 20Ohm |
| Terminal Finish | Tin/Lead (Sn/Pb) |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 240 |
| Number of Functions | 2 |
| Supply Voltage | 3.3V |
| Terminal Pitch | 0.65mm |
| Reach Compliance Code | not_compliant |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| Output | SEPARATE OUTPUT |
| Pin Count | 8 |
| Qualification Status | Not Qualified |
| Temperature Grade | INDUSTRIAL |
| Number of Channels | 1 |
| Operating Supply Current | 1μA |
| Number of Bits | 2 |
| Throw Configuration | SPST |
| Supply Type | Single |
| Off-state Isolation-Nom | 76 dB |
| On-state Resistance Match-Nom | 0.8Ohm |
| Switching | BREAK-BEFORE-MAKE |
| Switch-off Time-Max | 50ns |
| Normal Position | NO/NC |
| Height Seated (Max) | 1.45mm |
| Width | 1.6mm |
| RoHS Status | Non-RoHS Compliant |
| Lead Free | Contains Lead |
ISL43122IH-T Overview
The electronic part can be shipped overseas conveniently because it is packaged in SOT-23-8. To ensure high reliability, a new packaging method Tape & Reel (TR) is used. There are 8 terminations totally. This electronic part offers high-quality output due to its 1 channels. In the case of a voltage supply of 3.3V volts, the electrical part can be powered up and run. A total of 8 pins are injected into the electrical part body. A 20Ohm internal resistance characterizes this multiplexer. Please refer to the datasheets for 8 pins functions. In this analog multiplexer, the value is Multiplexer or Switches. A cost-effective Single supply type analogue multiplexer. For this multiplexer to operate, 1μA current would be sufficient. As far as the outputs go, this switch multiplexer utilizes SEPARATE OUTPUT of them. During operation, the multiplexer should not be exposed to a temperature above 85°C. The switch device is capable of conducting in a 2-bit mode.
ISL43122IH-T Features
1 Channels
1μA Supply Current
2-Bit
ISL43122IH-T Applications
There are a lot of Intersil (Renesas Electronics America) ISL43122IH-T Analog Switches & Multiplexers ICs applications.
- Fiber In The Loop (FITL)
- Automatic test equipment
- Microwave transmission systems
- DVD-R
- SDH/SONET multiplexers
- Relay replacements
- Switching Systems
- Intelligent PBX
- Communication systems
- DSLAMs
