ISL43140IV
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Package / Case | TSSOP |
| Packaging | Bulk |
| Published | 2001 |
| JESD-609 Code | e0 |
| Part Status | Discontinued |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 16 |
| Resistance | 65Ohm |
| Terminal Finish | Tin/Lead (Sn/Pb) |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 240 |
| Number of Functions | 4 |
| Supply Voltage | 5V |
| Terminal Pitch | 0.65mm |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| Pin Count | 16 |
| JESD-30 Code | R-PDSO-G16 |
| Qualification Status | Not Qualified |
| Supply Voltage-Max (Vsup) | 6V |
| Power Supplies | 3/12/+-5V |
| Temperature Grade | INDUSTRIAL |
| Supply Voltage-Min (Vsup) | 2V |
| Number of Channels | 1 |
| Operating Supply Current | 50nA |
| Number of Bits | 4 |
| Throw Configuration | SPST |
| Supply Type | Dual, Single |
| Neg Supply Voltage-Nom (Vsup) | -5V |
| Neg Supply Voltage-Max (Vsup) | -6V |
| On-state Resistance Match-Nom | 2Ohm |
| Switch-on Time-Max | 80ns |
| Switch-off Time-Max | 30ns |
| Normal Position | NC |
| Neg Supply Voltage-Min (Vsup) | -2V |
| Height Seated (Max) | 1.2mm |
| Length | 5mm |
| RoHS Status | RoHS Compliant |
| Lead Free | Contains Lead |
ISL43140IV Overview
The electronic part can be shipped overseas conveniently because it is packaged in TSSOP. Advanced packaging method Bulk is used to provide high reliability. In total, there are 16 terminations. This electronic part offers high-quality output due to its 1 channels. A 5V voltage supply should turn on and run the electronic component. Electronic part bodies are injected with 16 pins. Internally, this switch multiplexer has a resistance of 65Ohm. The analog multiplexer shown here is a typical Multiplexer or Switches. Analog switch ics with Dual, Single supply type are cost-effective. The analogue multiplexer could operate on 50nA current. The switches should not operate in an environment where the temperature is higher than 85°C. 4-bits are supported. To power the multiplexer ics, the voltage must be set at 2V.
ISL43140IV Features
1 Channels
50nA Supply Current
4-Bit
ISL43140IV Applications
There are a lot of Intersil (Renesas Electronics America) ISL43140IV Analog Switches & Multiplexers ICs applications.
- PBX interfaces
- Digital cross connects (DSX-1)
- Existing multiplexer applications (both fault-protected and nonfault-protected)
- Imaging
- Medical
- Audio and video routing
- Remote wireless modules
- ATM
- Low-Voltage
- DSUs
